Alfresco Home 310-1705 User manual

SavE ThESE
inSTrucTionS For
FuTurE rEFErEncE.
Assembly Instruction Item#: 310-1705

2
BEFORE YOU BEGIN
Before beginning assembly, make sure all parts are present. Compare parts received with the “Parts List.” If
any part is missing or damaged, do NOT attempt to assemble the product. Please read and understand this
entire manual before attempting to assemble, operate or install this product.
GENERAL INFORMATION
Your new patio furniture is made from the finest materials available. It should provide many years of
enjoyment with minimal care.
Keep your patio furniture clean and apply a coat of wax a few times a year. For best results, clean the patio
furniture with warm soapy water and use an outdoor furniture wax. If you use furniture covers, always make
sure the furniture is clean and completely dry before covering as mold may form in dark, wet places. Check
the bolts on your patio furniture regularly to make sure they are tight.
To provide a rust free product, this patio furniture is made of Cast Aluminum which is a relatively soft
material. Be careful not to over-tighten your hardware. Stripped hardware is not covered under the
manufacturer’s warranty. The weight limit for each seat is 225 lbs.
SAFETY INFORMATION
WARNING
DO NOT stand or allow children to stand on the assembled product. DO NOT tighten bolts completely until
instructed to do so. After final alignment, make sure all nuts and bolts are securely fastened. NEVER use a
power tool to assemble or tighten your furniture. Perform periodic checks to make sure the hardware is
secure and tighten if needed.
CAUTION
READ all instruction before beginning assembly. Failure to do so may result in faulty assembly and potential
injury. Assemble the items on a soft, non-abrasive surface such as a carpet or cardboard to avoid damaging
the item.
inForMaTion

PART DESCRIPTION QUANTITY
ASeat Bucket 1
BChair Base 1
I
Adjustable Foot
Qty: 4
(Pre-Installed)
HARDWARE CONTENTS
B
A
CD
F
H
Wrench
Qty: 2
E
PARTS LIST
（4forassy.+1extra)（4forassy.+1extra)
（4forassy.+1extra)（4forassy.+1extra)
G

Attach Chair Base B on the bottom of Seat Bucket A with Bolt C, Washer D
Spring Washer E and Nut F.
Tighten Bolts C with Wrench H.Use the Caps G to cover the Nuts F.
PrEParaTion
aSSEMBLY
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. Place all parts on a soft,
level surface for assembly. Estimated Assembly Time: 30 Minutes | DO NOT over tighten hardware!
1
2