AlkaViva Vesta H2 Operator's manual

Replacing The Filter(s)
In Your H2 Series Ionizer
Vesta H2, Athena H2 or Melody II
Watch the video below and learn how to replace
the lter(s) and reset the lter counter(s) in your
ionizer
vimeo.com/150375982
© AlkaViva, LLC - February 2017
To order replacement lters go to
alkaviva.com/water-ionizer-lters
or call Customer Support at [phone]
For any other quesons or help with lter installaon
please email
[e-mail]
We recommend you replace your lters at least once a year.
Date Installed:
Filter #1: ____________________________
Filter #2: ____________________________
For Private Wells
FIRST - You need to test your well water to make sure it is safe to drink. If
safe, we recommend using the external .01M UF Filter in place of one of your
lters. This external lter helps remove water-borne viral and bacterial
contaminants from potable water. This specialty lter is rated at 1/2 of the
life of an UltraWater Filter. We recommend that you replace this lter at 500
gallons or every 6 months, whichever comes rst.

When To Change My Filter
 Change lter at 999 WHEN BLINKING or ONCE A YEAR, whichever comes
rst.
 Filter life span can dier based on water quality in individual areas. We
recommend replacing the lter before the end of the life span is reached
if the water smells bad or the water ow volume decreases.
Possible situaons where lter life can be shortened drascally:
 When you have rusty water due to aged pipes.
 If there are a lot of impuries or sediment in the water for a short period
of me.
 If used in a place where the water pressure is very low.
How To Remove My Old Filter
Have a towel handy. Expect water to come out of your used lter.
Ensure that you install each lter in its proper place: Pre-lter goes in the
compartment on the right side. UltraWater Filter goes in the compartment on
the le side. This is noted on the lter label.
1. Open Both Filter Covers (Fig 1)
 Press and hold the white buon located at the
boom of the ionizer door (side of ionizer).
 While holding the white buon, li the lter
cover door straight up by pushing up with your
thumb at the boom edge.
 Remove the lter cover door.
2. Remove Old Filters (Fig 2)
 Twist the expired lter counterclockwise unl
the lter tab is aligned with the slot located at
the base of the lter compartment. Gently,
but rmly, pull up on the lter unl it is
released.
How Io Install Your New Filter
1. Install New Filter (Fig 3)
 Install your lter with RIGHT SIDE UP so you
can read the label.
 Remove the protecve scker on the boom
of each lter. (Boom as you read the label.)
 Insert the opening of the boom of the new
lter into the opening located at the base of
the lter compartment in the ionizer.
 Push down and twist clockwise unl locked
into place. You should NOT be able to li it
out. If the lter is not fully twisted, it could
cause leaking.
2. Reset the Filter Life Indicator (Fig 4)
 Push the Filter Reset Buon (Red on the right and
Green on the le.)
 You will hear one BEEP when you push it.
 Hold it down unl you hear a second BEEP. The
lter counter has reset. Release the buon.
3. Close The Cover (Fig 5)
 Align the tabs of the lter cover door with the
slots located on both sides of the lter
compartment.
 Press down unl lter cover door locks in place.
Fig.2
Fig.1
Fig.3
Fig.4
Fig.5