All Safety Products E SaniStand User manual

SAN2 Assembly - March 2020
E SaniStand®
Hand Sanitizer Stand
Page 1 of 4
Assembly Instructions
Height 52 in 132 cm
We recommend reading through the entire booklet prior to proceeding with use, service or maintenance.
Width 29.5 in 75 cm
Depth 29.5 in 75 cm
Weight Empty 17 lb 7.71 kg
SPECIFICATIONS
Dimension Imperial Metric
NOTE: All dimensions are subject to change due to environmental factors.
Shown with dispensers
Dispensers not included
The E-Sanistand stores fl at, can be easily assembled/
disassembled, and is a great answer to an immediate
need for hand sanitation. The mounting face of the stand
can accommodate dispensers up to 6.70 in. (17 cm) wide.
The unit can be assembled with the smooth fi nish out or a
textured fi nish out.
All Safety Products, Inc.
http://www.allsafetyproducts.com
P.O. Box 3822,
Lakewood, CA 90711-3822
Toll Free: 877.208.3109
Fax: [phone]
Email: [email protected]

SAN2 Assembly - March 2020
Page 2 of 4
Step 1: Insert the tabs of one panel into the slots of a second panel and slide
Assembly Instructions
down into place. Repeat this step for the remaining panels.
Wood Block
Step 2: For the fi nal panel, You will need to twist the whole assembly
to get the last tabs into the slots. To do this, place your foot or a piece
of a 2 x 4 wood block under the panel with the tabs and push down on
the panel with the slots. Place the bottom tab partially into the bot-
tom slot but do not fully install it. This will hold the two panels into
alignment and enable you to insert the remaining tabs into their cor-
responding slots. Once you have all the tabs inserted, you can ‘pop’
the tabs through the slots and the unit will fully engage.

SAN2 Assembly - March 2020
Page 3 of 4
Assembly Instructions Cont.
Step 3: Slide the leg brace into the slots located at the bottom of the panels and
insert the tabs into the corresponding slots. Pull the tab into the slots. Repeat this
for the other leg brace. You will have to guide the second brace under the fi rst brace
and into the slot of the side panel.
Step 5: Stand the unit upright. If you want to add a ballast of some sort (sandbag, gallon jug( S) of water/sand), do that
now by sliding the ballast down into the center of the Sani Stand. : Install your dispensers following the manufacturer’s recommended installation instructions.
Step 6
Step 4: Turn the unit upside down and line up the pre-drilled
holes in the two leg braces. Fasten into place using the
supplied PC-000105 rivet. If you would like to make the unit
more easily disassembled, you could drive a 5/16 -18 x 3/4”
bolt or screw into the two holes.
Step 7: Insert the tab on the top panel into one of the slots at the top of one of the
sides. Using a screwdriver or other tool to pry with, pry the opposite side out so
that the tab will insert into the corresponding slot.
Assembly is complete

SAN2 Assembly - March 2020
Page 4 of 4
SAN2-0001
Side Panel
SAN2-0003
Top Panel
SAN2-0002
Leg Brace
PC-000105 Rivet