All Things Cedar RC22U User manual

HARDWARE
1 ¾" Screw…38
2 ½" Screw…12
4" Screw…4
Carriage Bolt…4
Hex Nut…4
Washer…4
Rocker Instructions
(RC22U unassembled kit)
Tools Required: #2 Philips Drive, #2 Square Drive, Wood Glue.
( Its recommended wood glue be used on all dowel joints)
Step 1. Layout Parts
• Layout all parts as seen in the parts diagrams above.
Step 2. Build Rocker/Arm Assembly
•Position short leg near front of arm and long leg near rear of arm.
Attach the legs to the arms using dowels and 2-1/2 inch screws.
•Position rocker over leg assembly so that front (shorter) leg
is nearest to front of rocker, attach using 4 inch square drive screws.
Step 3. Build Seat Assembly
•Place sides approximately 21-1/4 inches apart.
•Attach front scallop using 1 ¾ inch screws.
•Place a seat slat so it overlaps front scallop and attach.
• Attach remaining seat slats + 1 rear cove slat with 1 ¾ inch
screws. Leave no spacing between slats - fit tight together.
PARTS:
(a) 2 arms
(b) 2 rockers
(c) 2 front leg
(d) 2 back leg
(e) 2 back supports
(f) 2 struts
(g) 7 back slats
(h) 2 sides
(i) 1 front scallop slat
(j) 5 seat slats
(k) 1 rear cove slat

Step 4. Build Back Assembly
•Set struts between back supports - position struts so
that larger bolt-hole is near the bottom. Attach back
supports to struts using 2 ½ inch screws.
•Using 1 ¾" screws attach outside slats first - then
attach center slat.
•Evenly space remaining slats and attach with screws.
Step 5. Final Assembly
•Place seat assembly on its side.
•Align bolt-holes on back assembly between bolt-holes on rear
seat.
•Position rocker/arm assembly so bolt-holes in both legs align with
bolt-holes on side of seat.
•Attach legs to seat using carriage bolts, washers and nuts.
•Using 1 ¾ inch screws finish attaching front seat to legs from the underside of seat.
•Set rocker upright, adjust back to align with rear arms
and attach rear arms using 1 ¾ inch screws.
♥Thank you for choosing All Things Cedar ♥
www.allthingscedar.com