All Things Cedar AA21U User manual

Adirondack Chair Instructions
(AA21U unassembled kit)
Step 1. Layout Parts
• Lay out all parts as seen in parts diagram above
Step 2. Build Back Assembly
•Place top and bottom back brace approximately 18-½ inches apart –
curved side up.
•Lay back slats in curved section of braces spaced at equal distances
apart. Attach using 1-3/4 inch screws.
• Attach the end slats first - then the center slat - followed by the
remaining slats.
Hardware
:
1-1/2 inch screw...16
1-3/4 inch screw…48
Carriage bolt…2
Washer…2
Hex nut…2
(A) 1 bottom back brace
(B) 7 back slats
(C) 1 top back support
(D) 2 back struts
(E) 1 front scallop slat
(F) 6 seat slats
(G) 2 sides
(H) 2 front legs
(I) 2 support blocks
(J) 2 arm paddles
Tools Required: #2Philips or Robertson screwdriver, and a ½ inch wrench.

Step 3. Build Seat Assembly
•Place sides approximately 20 inches apart.
•Attach scallop slat to front of sides using 1-3/4 inch
screws.
•Place back assembly from step 1 onto notches on
each side and attach using 1-3/4 inch screws.
•Evenly space 6 seat slats across sides and attach
using 1-3/4 inch screws.
Step 4. Build Leg Assembly
•Set support block against leg.
•Make support block flush with top of leg.
•Attach support block to leg using 1-3/4 inch screws.
Step 5. Final Assembly
•Attach back struts to top brace with 2 inch
screws. (position strut with high angle toward
front)
•Attach leg assembly to seat using bolts,
washers and nuts - tighten well and secure with
1-1/2 inch screws.
•Position arm paddle over leg assembly. Make
rear of arm flush with rear of strut and attach to
strut using 1-3/4 inch screws.
•Attach front of arm paddle through pre-drilled
holes in side of triangle brace using 1-3/4 inch
screws.
•Attach bottom of strut to sides using 1-1/2 inch
screws.
♥Thank you for choosing All Things Cedar ♥