ALLEN GROUP INT’L INC WF0004202 User manual

1
ALLEN GROUP INT’L INC
DARK GRAY CURVED CLASSICAL BENCH
MODEL # WF0004202
NOTE: The schematics in this manual are for assembly and operation illustration only. They may differ from the
bench’s actual appearance.
THANK YOU FOR YOUR PURCHASE OF THIS OUTDOOR BENCH. IF YOU ARE MISSING
ANY FASTENERS, OR NEED REPLACEMENT, PLEASE CONTACT OUR CUSTOMER
SERVICE DEPARTMENT BY [e-mail] OR TOLL FREE AT
1-866-321-0399, MONDAY THROUGH FRIDAY FROM 8:00AM TO 5:00PM.
ALLEN GROUP INT’L INC
377 South Lemon Ave, Suite AWalnut, CA 91789
Email: [email protected]
Customer Service Toll Free 1-866-321-0399
Monday through Friday from 8:00am to 5:00pm

2
ASSEMBLY INSTRUCTIONS
Step 1: Remove all of the parts from the carton and carefully place them on a clean level surface. Use caution to avoid
damaging the product. Make sure no parts are missing.
Step 2: Lay the bench top down with the holes facing up.(Noted: one nut is imbedded inside each hole)
Step 3: Position the bench legs on the bench top, pay attention to have letter sticker “A, A1, B, B1” on bench top. Make
sure the bench top letters align with the same letters that are on the bench legs. The metal tabs align with the
holes.
Step 4: Place one washer on each bolt.
Step 5: Insert the bolts through the metal tab.
Step 6: Thread the bolts into the nuts and tighten by hand. Do not tighten completely.
Step 7: Check the alignments of the legs and securely tighten all bolts using the wrench (Included).The bench is
completely assembled as shown in Fig 2.
WARNING! Always use this bench on level and stable surfaces! Never use this bench on
inclined,uneven, or unstable surfaces! Improper use may result in serious injury!