ALLIANCE 7SMGIAAH07 User manual

ASSEMBLY INSTRUCTIONS
7SMGIAAH07
GIAAHT07
NOTE:
Please carefully read through instructions once before proceeding with assembly.
(1) Heavy load, 2 or more adults are recommended to assemble.
(2) Proper lifting posture is recommended to avoid injuries.
(3) Table contains small parts & components not suitable for children.
(4) Table contains joints and connecting parts. Care should be taken during stowage &
assembly
(5) Products is free standing. Efforts should be made to ensure product is used on even
surface.
Part Description Quantity
Leg Bolt: 12
Washer: 12
Leg Leveller 4
Round end panel screw 12
Flat head scorer screw 4
Table Legs 4
Legs Panel 2
COMPONENTS:
Air Hockey Table
1
2
3
4
5
6
7
PG3
6. Attached scoring system securely to pole.
* Place scoring system in pre-defined
location on side of table.
* Secure scoring system with four (4) flat head
screws.
* Connect scoring system cable and sensor
cable to junction box.
Scoring System 1
8
HOME VISITOR
ON
OFF
RESET
HOME VISITOR
ON
OFF
RESET

1. Place table face door on smooth even
surface.
* Ensure assembly surface is free of any
debri.
* Carton box top can be used to line floor
surface to reduce change of scratching
table.
ASSEMBLY INSTRUCTIONS
7SMGIAAH07
GIAAHT07
Air Hockey Table
3. Screw in table leg leveller base
* Do NOT over fasten or tighten. Adjustment
may be required to adjust table height and
levels.
4. Attached end panel between installed
table leg.
* Ensure pre-fabricated screw holes face
inwards.
* Align screw holes on end panel to those
on table legs.
* Secure end panel screws three (3) per
leg with six (6) per end panel as per
diagram.
* Screws should thread through end panel
first then table leg.
PG1 PG2
5. Requiring atleast 2 people, flip table
back to up right position.
* Heavy load: Caution must be taken
when turning table up right. Where
additional assistance is recommended
2. Assemble table legs to table base.
* Pre-fabricated screw holes should face
inside of table.
* Thread bolt with washer through both
base board as well as table leg from
inside outwards.
* Fasten legs securely to table base with
three (3) bolts per leg. Repeat for all
legs.
6
6
6
6
4