AllMounts AS01T01 User manual

INSTALLATION MANUAL
AS01T01
27"
MAX
75x75
100x100
ISSUED: OCT. 2014
8kg
(17.6lbs)
RATED
8kg
(17.6lbs)
RATED
Monitor Table Stand
CAUTION: DO NOT EXCEED
RATED LISTED WEIGHT. SERIOUS
INJURY OR PROPERTY DAMAGE
MAY OCCUR!

21
NOTE: Read the entire instruction manual before you start installation and assembly.
WARNING
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• Make sure that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
Component Checklist
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, telephone your local distributor for a replacement.
Package M
adapter bracket
assembly (x1)
A
pole
B
(x1)
M4x14
M-A
(x4) M5x14 (x4)
M-B
D5 washer (x4)
M-C
Package P
4mm Allen key
P-B
(x1)3mm Allen key (x1)
P-A
base
C
(x1)

4
34 3
articulated arm assembly VESA Plate
P-A
tighten
P-A
loosen
P-A
Loosen screws on the base. The pole is screwed into the
threaded hole of the base.
Tighten screws to secure.
• Use Allen key to loosen the screws in
order to separate the VESA plate from the
adapter bracket assembly.
• Retain these screws for later use.
P-A
B
1. Separating the VESA Plate 2. Assembling the Pole to Base

65
3. Installing the Articulated Arm Assembly
tighten
Note: Plastic handle can
be pulled out due to a
limited amount of space.
Insert the articulated arm assembly
into the pole untill it touches the collar.
collar
adjust handle
collar loosen
adjust height
P-A
tighten
P-A
Adjust the collar to the desired
height as needed.

87
5. Installing the Display
6. Cable Management
Use clips for routing the cables.
Note: Leave slack in the cable for arm movement.
Tighten all screws but do not over tighten.
Screw the VESA plate onto the display.
TV
TV
TV
4. Installing the VESA Plate
Top of display
M-A
M-B
M-C
P-A
Insert the VESA plate onto the mount and use the previously removed screws to secure them. Make sure
the display is safely secured before finally releasing.

9
Maintenance
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).
• Please contact your distributor if you have any questions.
10
7. Adjustment
+15°
-15°
360°
P-B
Adjust to the desired position or tilt.
Slightly loosen or tighten the screws
as required due to different weights
of the displays.
+15°
-15°