Alpine SERRANO 42 SERIES User manual

THE SERRANO 42 SERIES
FIREPLACE SPECIFICATIONS AND INSTALLATION INFORMATION
Minimum Opening
Fireplace Dimensions
Framing Dimensions FRONT VIEW
TOP VIEW
LEFT SIDE VIEW
CORNER INSTALLATION WALL OR CHASE INSTALLATION
The SE Series is a zero-clearance fireplace. The fireplace has spacers attached to
assist in a correct installation. Combustible materials may touch the spacers, but
must never be notched , cut, or modified to come closer to the appliance than the
spacers allow.
PLATFORM INSTALLATION FLOOR LEVEL INSTALLATION
The above framing diagram does not show a hearth. A hearth is not required,
but often used with this appliance. If a hearth is desired, it must be constructed
so as not to inhibit the valve access door at the bottom of the appliance. The
hearth need not conform to codes applicable to solid fuel appliances. File:U\user2\randy\SE42spec
20.5"
42-1/2" Minimum
38" Minimum
* As Required By Design
20.5"
42-1/2" Minimum
38" Minimum
SE-42 SERIES
Weight: 250 lbs
BTU Input: 41,500
outside air may come in on either side
57"
80"
If Rectangular Ducting (Part # 04075) is
used, dimensions can be reduced by 3.5”

System Specifications Gas Supply Line Location
GAS LINE SUPPLY
Venting Requirements
Gas Supply Inlet
Left Side
of Fireplace
0
2
4681012
0
2
4
6
8
10
12
14
Side View of
Fireplace
6"
Mantel
12" Mantel Sheetrock
6"
Top of
Fireplace
12"
tile or other non
combustible facing may
be placed against the
fireplace or even
overlap the fireplace
face.
sheetrock and other
combustibles may be
brought to within 1/2"
of the fireplace face
but may not overlap or
even contact the
fireplace.
Facing and Mantel Requirements
Horizontal Venting Options Vertical Venting
Alpine SE series
products have been
tested extensively for
venting options of up
(4) 90 degree elbows or
(8) 45 degree elbows
Contact your local
Alpine retailer for
more information
about the many
venting options
possible with Alpine
SE Products.
Mantel Clearances
Gas Input Rating:
Nat. Gas 41,500
Propane 38,000
Rated Manifold Pressure:
Nat. Gas 3.5” w.c.
Propane 10” w.c.
Minimum Gas Line Pipe Size: 1/2”
Electrical : 120 V.A.C.
Amperage Rating: 3.25 / 3.5 Amps