Altec COMFORTQ MZX770 User manual

Paired
Powering On and
Bluetooth Pairing
12:12 PM
Bluetooth
Bluetooth
Devices
ON
Now discoverable
Altec ComfortQ
6 Seconds Pairing: Red&Blue
Flashing LED
Indicator
Answering Calls
Volume Up
Volume Down
Answer Call
PRESS
PRESS & HOLD
Ignore Call
Controlling
Music/JUST ASK
For additional user materials and
warranty information, please
visit alteclansing.com
PRESS
Play
Next Track
Previous Track
PRESS & HOLD
Volume Up
Volume Down
PRESS x2
JUST ASK (Google/Siri)
MZX770
QUICK START GUIDE
COMFORTQ HEADPHONES
Charging
Indicator
= Charging
O = Charged
~6.5 Hours
red
In the Box
USB Cable
Airplane Adaptor
AUX Cable
ComfortQ
Headphones
A Closer Look
Power/Play/Pause
Volume Up/
Next Track
Volume Down/
Previous Track
Aux Input
Active Noise
Cancellation Switch
LED
Microphone
LED
Charging
Indicator
USB Charging
Port

FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation .
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates. uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception , which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio / TV technician for help.