Altelix BMP-YLK1-DIN User manual

BMP-YLK1-DIN
Installation Guide
Altelix LLC USA: 866-660-WIFI (9434) International: [phone] [email protected] www.altelix.com
Copyright (C) 2023 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See www.altelix.com for most current information
IS0208 Rev B 08/04/23 YoLink® is a trademark or registered trademark of YoSmart, Inc.
Product Note: The YoLink® Hub is currently available in two sizes. This mount is specifically designed for
the YoLink® Hub measuring 4.33" x 4.33"square. It will not work with the smaller YoLink® Hub which
measures 3.38" x 3.38"square. Please check the size of your YoLink® Hub before ordering to insure
proper fit.

BMP-YLK1-DIN Installation Guide
The BMP-YLK1-DIN is designed to mount directly to a 35mm Top Hat DIN rail
using the supplied DIN rail mounting clip.
DIN Rail Mounting Clip
To install, using the supplied hardware
attach the DIN rail mounting clip to the
back of the BMP-YLK1-DIN as shown.
Once the BMP-YLK1-DIN is mounted to a
DIN rail, insert the YoLink hub into the
cradle as shown.
Note: 35mm Top Hat DIN rail not included.
IS0208 Rev B 08/04/23