Altelix NRR-E1 User manual

NRR-E1
Installation Guide
Altelix LLC USA: 866-660-WIFI (9434) International: [phone] [email protected] www.altelix.com
Copyright (C) 2023 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See www.altelix.com for most current information
IS0205 Rev A 07/05/23

NRR-E1 Installation Guide
Step 1 –The NRR-E1 can be installed into panels up to 6mm (0.23 in.) thick. To install
the weatherproof IR receiver, following all applicable safety precautions drill a 26mm
(1.02”) diameter hole. Install the IR receiver housing into the hole and secure with
clear cover, hand tightening only. Be sure to ensure the cover gasket is properly
seated.
Step 2 - Plug the USB into your TV, set top box or other device for power (you may
also use a USB wall adapter –not included), then paste the IR transmitter using its
own adhesive over the IR receiver on the device you wish to control.
Recommended
Mounting Hole Size
IS0205 Rev A 07/05/23
Inside Equipment Enclosure
Installs into panels up to
6mm (0.23 in.) thick
Media Equipment
IR Transmitter
USB Power
2m
(6.4 ft.)
1.3m
(4.2 ft.)
IR Remote
30°IR Receiver Cover
26mm
(1.02 in.)
IR Receiver Housing
Installation Note: Avoid
installing in locations
where the IR receiver is
pointing to into direct
sunlight. This may interfere
with IR signal.