Altelix BMP-YLK1 User manual

BMP-YLK1
Installation Guide
Altelix LLC USA: 866-660-WIFI (9434) International: [phone] [email protected] www.altelix.com
Copyright (C) 2023 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See www.altelix.com for most current information
YoLink® is a trademark or registered trademark of YoSmart, Inc.
IS0207 Rev B 08/04/23
Product Note: The YoLink® Hub is currently available in two sizes. This mount is specifically designed for
the YoLink® Hub measuring 4.33" x 4.33"square. It will not work with the smaller YoLink® Hub which
measures 3.38" x 3.38"square. Please check the size of your YoLink® Hub before ordering to insure
proper fit.

BMP-YLK1 Installation Guide
The BMP-YLK1 can be directly mounted to the inside of a network equipment
cabinet using the included double-sided tape. For wall mounting, wall anchors
and screws are also provided.
Double Sided Tape
Wall Anchors and Screw
To use the included double-sided tape,
firmly attach to the rear of the BMP-YLK1
as shown.
For wall mounting use the drill template
below.
Once the BMP-YLK1 is mounted, insert
the YoLink Hub into the cradle as shown.
Drill Template for Mounting Holes
Place the template in the desired
mounting location and mark the holes.
Follow all applicable safety precautions
when drilling. If necessary, drill pilot holes
where you made your mark. If you will be
using the wall anchors provided with your
enclosure drill 3/16 inch holes. If you will be
using the screws directly, drill 3/32 inch
holes.
Printing Instructions
Print onto 8-1/2” x 11” paper. Select
“Actual Size” or “100% Scale” when
printing.
Installation Note: If attaching to surfaces such as glass, mirror and tile, be sure to clean
surfaces first with alcohol wipes or glass cleaner
IS0207 Rev B 08/04/23