C
01 02
• Check package contents against supplied parts and hardware list to assure that all
components were received undamaged. Do not use damaged or defective parts. lf you
require replacement parts, please contact amada customer service at
• Carefully read all instructions before attempting installation. If you do not understand the
instructions or have any concerns or questions, please contact customer service at
• Not all parts and hardware included will be used.
• Do not use this product for any purpose that is not explicitly specified in this manual. Do
not exceed weight capacity. We cannot be liable for damage or injury caused by improper
mounting, incorrect assembly or inappropriate use. Thank you for your understanding.
IMPORTANT SAFETY INFORMATION
Tools Needed (Not lncluded)
Step 1 Adjust the Coat Rack to the Desired Width
Supplied Parts and Hardware
Wall Anchor
M13x42mm
x4
D
CAUTION!
This wall anchor [D]
are for drywall ONLY.
DO NOT use them in
concrete / brick / wood
studs wall.
CAUTION!
This wall anchor [E] is
for concrete or brick
walls ONLY. DO NOT
use them in drywall or
wood studs.
Wall Anchor
x4
E
M6x30mm
Long Lag Screw
M4x50mm
(C) x4
Stud Finder Pencil Phillips Screwdriver
5/64 in.(2mm)
Wood Drill
13/64 in.(5mm)
Concrete Drill
Drill
Hammer
Coat Rack
(A) x2
Step 2B For Drywall Installation
[Not Included] [Optional]
1 31/32 in.(50mm)
ø5/64 in.(ø2mm)
Step 2A For Wood Stud Installation
Short Lag Screw
M4x35mm
(B) x4
For wood stud mounting, wall
anchors [D] and [E] are not
necessary.
WARNING:
XX
D E
16 in.
(406 mm)
D
B
