Amada AMPS01 User manual

Thank you for choosing this AMADA product! At AMADA we
strive to provide you with the best quality products and ser-
vices in the industry. Should you have any issues, please don't
hesitate to contact us at [email protected](US/CA)
Tripod Stand Instruction Manual V3.0
Model: AMPS01/AMPS01K
Step 2 Secure the Metal Clamps into the Middle of the Rubber Grips
Step 3 Secure the Tray to the Metal Clamps
Step 4 Adjust the Tilt Angle and the Height
04 05
Note:
● The holes in the metal
clamp should be aligned
with the holes on the tray.
● Do not tighten the bolts
[F] until all of them are in
right positions.
F
G
E
B
D
H2
H1
S
T T T T
Tilt Adjustment
Height Adjustment of Tray Support Leg
1. Remove the safety pin [S] from the
tray support leg.
2. Slightly loosen the height adjustment
knob [H1] for better to adjust the height.
3. When you adjust the tray support leg
to your desired height, tighten the knob
[H1] and insert the safety pin [S] into the
hole of the tray support leg.
Height Adjustment of Tripod Stand
1. Slightly loosen the height adjust-
ment knob [H2] for better to adjust the
height of the tripod stand.
2. When you adjust the tripod stand to
your desired height, tighten the knob
[H2] to secure the height in place.
Tilt Adjustment of Tray
Slightly loosen the tilt adjustment knobs
[T] for better to adjust the height. When
you adjust the tray to your desired tilt
angle, tighten the knobs [T] to secure
the height in place.

• Check package contents against supplied parts and hardware list to assure
that all components were received undamaged. Do not use damaged or
defective parts. lf you require replacement parts, please contact amada
customer service at [email protected].
• Carefully read all instructions before attempting installation. If you do not
understand the instructions or have any concerns or questions, please contact
customer service at [email protected].
• Not all parts and hardware included will be used.
• Do not use this product for any purpose that is not explicitly specified in
this manual. Do not exceed weight capacity. We cannot be liable for damage
or injury caused by incorrect assembly or inappropriate use. Thank you for
your understanding.
IMPORTANT SAFETY INFORMATION
Supplied Parts and Hardware
Specification
Foldable Tripod Stand
A (x1)
Tray
B (x1)
Tray Support Leg
C (x1)
Metal Clamp
D (x2)
Wing Nut
E (x4)
Bolt
F (x4)
Washer
G (x4)
14.0 in.
Height Adjustable
22.0 in.-35.0 in.
11.0 in.
Step 1 Secure Tray Support Leg into Tripod Stand
01 02 03
Connector
with Knob
H (x1)
13/64 in. (5mm)
Allen Key
I (x1)
H
A
I
C
I
Height Adjustable