Amada AMPS01 User manual

• Check package contents against supplied parts and hardware list to assure
that all components were received undamaged. Do not use damaged or
defective parts. lf you require replacement parts, please contact amada
customer service at [email protected].
• Carefully read all instructions before attempting installation. If you do not
understand the instructions or have any concerns or questions, please contact
customer service at [email protected].
• Not all parts and hardware included will be used.
• Do not use this product for any purpose that is not explicitly specified in
this manual. We cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use. Thank you for your understanding.
IMPORTANT SAFETY INFORMATION
Supplied Parts and Hardware
Specification
Tray
B (x1)
Connector
C (x1)
M4x10 mm
Bolt
D (x4)
Step 1 Adjust the Height of the Tripod
01 02 03
Height Adjustable
Foldable Tripod Stand
A (x1)
Slightly loosen the knob.
1-2
1-1
When you adjust the pillar to your desired height,
tighten the knob, then insert the safety pin into the
hole on the pillar.
Warning: When you unfold or
fold the tripod, please be careful and
avoid pinch areas such as the upper
section of the supporting leg. DO
NOT place hands on or near the
joints of the supporting leg.
Height Adjustable
22.44 in -36 in
(570 mm - 915 mm)
16.0 in
（406 mm）
11.0 in
（280 mm）
Phillips
Screwdriver
(Not Included)

Phillips
Screwdriver
(Not Included)
Tripod Stand Instruction Manual
V3.0(B)
Model: AMPS01
Step 2 Secure the Connector to the Top of the Tray Support Leg
Step 3 Secure the Tray to the Connector
Step 4 Tilt and Height Adjustment
04 05
Note:
●The holes in the connector should be aligned with the holes on the
tray.
●Do not tighten the bolts [D] until all of them are in right positions.
Height Adjustment of Tray Support Leg
1. Remove the safety pin [M] from the
tray support leg.
2. Slightly loosen the height adjustment
knob [N] for better to adjust the height.
3. When you adjust the tray support leg
to your desired height, tighten the knob
[N] and insert the safety pin [M] into the
hole of the tray support leg.
Height Adjustment of Tripod Stand
1. Slightly loosen the height adjust-
ment knob [O] for better to adjust the
height of the tripod stand.
2. When you adjust the tripod stand to
your desired height, tighten the knob
[O] to secure the height in place.
Tilt Adjustment of Tray
Slightly loosen the tilt adjustment knobs
[K] for better to adjust the height. When
you adjust the tray to your desired tilt
angle, tighten the knobs [K] to secure
the height in place.
Tighten the knob
Thank you for choosing this AMADA product! At AMADA we strive to
provide you with the best quality products and services in the industry.
Should you have any issues, please don't hesitate to contact us at
[email protected]
K
D
O
N
M