Amano MTX-30P PUSH User manual
MTX-30P & MTX-30F Push WiFi Setup Guide Page 4
For support, please call 1-800-896-7035 (option 3) or
5. With your USB still inserted into the time clock unit, choose Upload
WiFi Password.
6. Select the Load Password option using the down arrow and then
Press OK (M/
). The password will populate from the thumb drive
and be obscured by **********.
Use the down arrow key to highlight the “ok(M/
)” Icon and
press (M/
) to enter
“Rebooting wireless device” will appear, this is normal
Wait for the unit to revert back to home screen, when
successful, the MTX-30 unit will connect to your Wi-Fi
network and show the WiFi icon in top right corner of screen.
Press the (M/
)
Once you see the WiFi icon in the top right corner of the screen confirm it
is connected to the correct network by pressing OK (M/
), selecting
Comm. and pressing OK (M/
) and then selecting Wireless Network
and pressing OK (M/
).
If connected correctly, the SSID will display your WiFi name. (Make note
of the IP address displayed for future reference, if necessary.)
Verifying & Performing Ping Test
Ping the IP address displayed using the Windows command prompt.
This is done by clicking the windows start button and typing CMD.
At the command prompt type “ping IP address” and press enter.
If successful, you will get 4 replies. If ping times out please
call support at 1-800-896-7035.
If successful, add a location (and terminal 1) to Time
Guardian and set time in Comm.
MTX-30P and
MTX-30F PUSH
WIFI SETUP GUIDE
MTX-30P & MTX-30F Push WiFi Setup Guide Page 2 MTX-30P & MTX-30F Push WiFi Setup Guide Page 3
In order to use your MTX-30P or MTX-30F Push unit you will
need to connect it to WiFi.
If your WiFi password is alphanumeric, you must first create a
WiFi password file using a USB thumb drive (not included).
To Create A WiFi Password File
1. Plug your USB thumb drive into a Windows based PC.
2. Open the Windows Notepad application.
This can be done by clicking the Windows start button
and typing “Notepad” and click on the notepad app
icon to open.
3. Once the Notepad application opens type the following line
inside Notepad: WirelessKey=enter your specific WiFi
password here
EXAMPLE:
Next, click “File” and then “Save As”.
When saving your file, make sure the location you are
saving to is the USB drive.
Type the filename “updataoptions2.cfg” then click Save.
After confirming that the file has saved to your USB, remove the
USB from your PC and plug it into the MTX-30P or MTX-30F
Push clock which is located on the left side of the unit.
USB Port
1. Press the Menu button (M/
)to
display the Main Menu.
2. Using the arrows highlight the
COMM. icon and then press OK.
3. Highlight Wireless Network and
then press OK (M/
)
4. Use the arrows to select your
WiFi SSID name, then Press
the OK (M/
)button.
Other manuals for MTX-30P PUSH
1
This manual suits for next models
1
