Ambir DB100 User manual

DB100/BR100 User Guide
1.Reset to default
Factory default
2.Interface setting
USB Keyboard
3.Output setting
*Remove newline
Soware version number.
V2.1.20.1126
5.Beeper setting
*On
Off
* Add "Enter"
Remove "Enter"
Add newline
4.Case switching
* Default case setting
All lowercase
All uppercase
6.Language output setting for USB HID
*Default
For Microso Word
The keyboard mode supports
output of other languages by
scanning the corresponding
configuration code. (The default
is English, but other languages
can be input)
The default is English,
but other languages
can be set.
For Microso
Excel & Notepad
PLEASE NOTE: By scanning the “Factory
default” settings code, all settings of the
barcode scanner will be restored to factory
default settings. Codes marked “ * ” below
are the default settings.
Register your product
www.ambir.com
UG_DB100.BR100_Ver_1.0

9. Notice
Check whether the USB cable is successfully connected
to the computer. If it is connected correctly, there will be
a prompt sound. The driver installation will appear when
connecting to the computer for the first time. Aer the
driver is automatically installed, scan the code to test
whether there is a decoding prompt sound.
If the decoding is normal, please scan the USB
Keyboard in this Setup manual.
If there is no response aer scanning the code, please
scan "Recall default" and then plug it in again.
If there is no response aer re-powering, or no
response aer scanning the setting code, please contact
the dealer's for technical support.
10. Use equipment correctly
Please use the scanner aer the device has finished
booting to prevent the device from being unable to
recognize the scanner or causing the device to start
abnormally. (You can try re-plug the device to solve
this problem)
The following is the test barcode, which is used for
transmission test.
2D barcode test
12345678
8. Barcode setting
1D barcode test
1 2 3 456789 0 1 93
Italy
Spain
*USA
Singapore
Salvadora
Japan
Sierra Leone
Turkey
Check whether the cable is firmly connected (there will
be a crisp sound aer the USB cable is connected to the
device) and then check whether the USB is properly
connected to the device. If it is not powered on, then try
to connect the USB port behind the host.
Enable url QR code
Disable url QR code 2D desktop barcode
scanner default disable.
2D handheld barcode
scanner default enable.
7. Language
Thailand
Belgium
7. Language (Continued)
2. Data is not uploaded.
1. Scanner cannot be activated.
Russia
Hungary
Russian
Germany
Spanish Latin
British
France
"windows1251"
"Shi-jis"
Algeria & Arabic
FULL ASCII