Amcor AHW 162 User manual

Installation Guide
Amcor
Split Air Conditioners
Andrew Ziegler
Dir. Product Management
Amcor USA

1. Remove compressor for outside installation from shipping box.*
Compressor should be mounted either on level base slab, or squarely on wall bracket.
2. Remove AC blower unit for inside installation from shipping box.*
*Any visible damage to Amcor products must be reported directly to manufacturer
within twenty four hours of delivery, in order to claim damage for replacement unit or component
Step 1. Getting Started

Remove metal electrical
plate cover as shown.
Step 2. Remove Metal Shield

See plastic shield
cover.
Step 3. Remove Plastic Shield

Remove plastic shield
cover screw.
Step 4. Remove Plastic Shield

Now you are ready to
wire up the unit..
It is best not to put
these parts on delicate filter. This
just shows removal of (2) parts..
Step 5. Ready to Wire

After exposing the front wiring panel, carefully flip the unit over, resting it
on cardboard box or other protective surface.
.
Step 6. Care In Turing Unit Over

Remove the wall mounting bracket and set aside.
.
Step 7. Remove Wall Bracket

See wire cable management cover at lower left.
Remove single screw as shown by arrow.
.
Step 8. Remove Wire Mgt Cover

Remove the wire
management cover.
.
Step 9. Remove Wire Mgt Cover

Thread wire harness
Through the hole in the
Wire management
cover.
.
BACK VIEW OF UNIT
Step 10. Threading Wire Harness

Thread wire harness
up through the interior
cavity of the part,
pulling harness to
front of the unit as
shown..
.
Remove
the plastic wire
clamp screw.
.
FRONT VIEW OF UNIT
Step 11. Wire Harness Clamp

Remove
the plastic wire
clamp part.
.
Step 12. Wire Harness Clamp
FRONT VIEW OF UNIT

Y/ GN
FUSE
NO
L
CNB S(N)
CNC
BK
BK
BL
AHW164
AHW162
Step 13. Wiring Schematics

Step 14. Replace Wire Harn. Clamp

Step 15. Replace Wire Mgt. Cover

Step 16. Replace M. Wire Mgt Cover

Step 17. Flip Cover Back Down

Remove shipping galvanized hose clamp from AC lines, and swivel
lines to come out of left or right hand side, or back, as desired. This is
accomplished by selectively punching out “PUNCH OUT” slot provided
at desired location.
Step 18. Back Preparation

Rotate electrical conduit and outflow pipe to either left, right, or bottom
left (as shown). If desired to come our left or right side of unit, see next
slide for punch out detail.
Step 19. Back Preparation