American DJ Flash-2C User manual

American DJ®LOS ANGELES, CA. 90058 USA • www.americandj.com
Model: Flash-2C™
SPECIFICATIONS:
Power: 110V/60Hz
Weight: 8 lbs.
Size: 19” x 3.5” x 5”
Fuse: 15A
Thank you for purchasing this
American DJ® product. For your
convenience this products ready to be
used, there is no assembly required.
Please read the following
instructions before installing or using
your new unit.
Operating Instructions:
The American DJ® Flash-2C, flash tube controller is
ideal for mobile DJ’s and club use. One Flash-2C will
control 4 expandable lines of Flash Tubes.
POWER- ON & OFF
1,2,3,4 - ON & OFF for individual lines.
SYNC - All tube flash at the same time
AUTO - Flashes line of tubes one by one
SPEED knob - Controls speed of chase.
RATE knob - Controls rate of pulse (ie. speed
between triggering strobe) of the Flash Tubes.
TRIGGER - starts a flash run when in manual mode
MANUAL - allows you to TRIGGER flash manually.
MODE SELECT - Choose 1 of 4 modes to chase in.
1. Rebound
2. Crossover
3. Reverse
4. Forward
For service, contact your American DJ®dealer.
American DJ®User Instructions
Flash-2C™
POWER
ZONE CONTROL PULSE CONTROL
1234SYNC AUTO
MODE SELECT FLASH MANUAL
SPEED RATE
AUDIO TRIGGER
SET UP:
Link the Flash Tubes to the Flash-2C™ by inserting tube
connectors into controller sockets on the back of unit.
The maximum length to first Flash Tube™ is 10 ft, any
more and you will have to use a Flash Buffer.
If you connect more than 30 Flash Tubes in any single
line use a Flash Buffer™ to boost signal.
At the end of each line connect a Flash-Term™. If you
don’t use one the Flash Tubes will work but not properly.
Plug Flash-2C™ and any Flash Buffer™ into power.
Refer to Operating instructions for use.
4 CHANNEL FLASH TUBE CONTROLLER
Caution! Always use appropriate cables and
connectors. Remember to always replace with
same fuses. Always keep controllers dry. Don’t
exceed load and length limitations