American DJ Mini Flame LED User manual

Customer Support:
American DJ®provides a toll free customer support line, to provide set
up help and to answer any question should you encounter problems
during your set up or initial operation. You may also visit us on the web
at www.americandj.com for any comments or suggestions. For service
related issue please contact American DJ®. Service Hours are Monday
through Friday 9:00 a.m. to 5:00 p.m. Pacic Standard Time.
Voice: [phone]
Fax: [phone]
E-mail: [email protected]
To purchase parts online visit http://parts.americandj.com
Warning! To prevent or reduce the risk of electrical shock or re, do
not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures war-
ranty. In the unlikely event your unit may require service please contact
American DJ.
PLEASE recycle the shipping carton when ever possible.
Safety Issues: This unit may blow a fuse if the maximum allotted
load of 1 amp is reached. If the fuse needs replacement, always
replace the fuse with same exact type that was remove, unless oth-
erwise instructed by an authorized American DJ®service technician.
Use of a different type fuse from that which is recommended may
cause fire or electric shock and will void the manufactures warranty.
Mini Flame LED Unpacking
©American DJ Supply®- www.americandj.com - Mini Flame LED Instruction Manual Page 2
Mini Flame LED Introduction
Thank you for purchasing the Mini Flame LED by American DJ®. Every
Mini Flame LED has been thoroughly tested and has been shipped in
perfect operating condition. Carefully check the shipping carton for
damage that may have occurred during shipping. If the carton appears
to be damaged, carefully inspect your unit for any damage and be sure
all equipment necessary to operate the system has arrived intact. In
the event damage has been found or parts are missing, please contact
our toll free customer support number for further instructions. Please
do not return the unit to your dealer without rst contacting customer
support.
User Instructions
3/08
American DJ®
6122 S. Eastern Ave.
Los Angeles CA. 90040
www.americandj.com

Introduction: Thank you for purchasing the Mini Flame LED by
American DJ®. This unit can only be set on a flat surface. For best
results, use a fog or haze machine to enhance the beam output.
Please read the following instructions before installing or operating
your new Mini Flame LED.
Operating Instructions: Plug the unit in to a matching power outlet
or into a power pack. The power switch is located on the bottom of
the fixture. Put the switch into the “On” position and the fixture will
start working automatically.
Mini Flame LED Operation
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and mainte-
nance of this unit. Please keep this manual with the unit, for future
reference.
Mini Flame LED General Instructions
• Keep the outside of this device dry at all times. Do not spill water
or other liquids into or on to your unit. To prevent re or shock
hazard, do not expose this product to rain or moisture.
• Be sure to save the packing carton in the event you may have to
return the unit for service.
• This unit is designed for interior use only. Do not use this unit out
doors. Use of product outdoors will void the warranty.
• Be sure that the local power outlet match that of the required vol-
tage for your unit.
• Do not attempt to operate this unit if the power cord has been
frayed or broken.
• Always route your power cord out of the way of foot trafc.
• Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and re in the rare case of an internal short.
• Disconnect the unit’s main power when left unused for long peri-
ods of time.
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• Never block the ventilation holes.
• Do not attempt to operate this unit, if it becomes damaged in any
way.
• Never operate this unit when it’s cover is removed.
• This unit is for adult use only. Keep out of the reach of children.
Mini Flame LED Cleaning
©American DJ Supply®- www.americandj.com - Mini Flame LED Instruction Manual Page 4©American DJ Supply®- www.americandj.com - Mini Flame LED Instruction Manual Page 3
Mini Flame LED Precautions
If the silk drape becomes creased, you may iron the ame using a non-
drip iron on a low setting. Do not steam iron.
If the silk drape becomes frayed, you may use a sharp pair of scissors
to carefully cut the loose silk strands. The silk drapes may become
frayed after a period of four weeks.
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning should be carried out
periodically to optimize light output. Cleaning frequency depends on
the environment in which the fixture operates (I.e. smoke, fog residue,
dust, dew). In heavy club use we recommend cleaning on a monthly
basis. Periodic cleaning will ensure longevity, and crisp output.
Always be sure the unit is turned off and unplugged before perform-
ing any cleaning procedures.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Use a brush to wipe down the fan grill.
3. Gently wipe down the LEDs with soft brush to remove all residue
and dust.
4. Always be sure to dry all parts completely before plugging the unit
back in.
Mini Flame LED Silk Drape

©American DJ Supply®- www.americandj.com - Mini Flame LED Instruction Manual Page 5
Mini Flame LED Warranty Registration
The Mini Flame LED carries a 3 year (1095 days) limited warranty. We
recommend you fill out the enclosed warranty card to validate your
purchase. All returned service items whether under warranty or not,
must be freight pre-paid and accompany a return authorization (R.A.)
number. If the unit is under warranty, you must provide a copy of your
proof of purchase invoice. Please contact American DJ®customer
support for a R.A. number.
©American DJ Supply®- www.americandj.com - Mini Flame LED Instruction Manual Page 6
Mini Flame LED Warranty
Mini Flame LED Fuse Replacement
Disconnect from the main power supply. Insert a standard flat head
screw driver in to the fuse holder housing, located on the bottom of the
unit. Turn the screwdriver in counter-clockwise direction to remove the
fuse holder. Remove the old fuse and discard it, replace the fuse with
the same type. Insert the fuse back into it’s housing.
MANUFACTURER’S LIMITED WARRANTY
A. American DJ, Inc. hereby warrants, to the original purchaser, American DJ and American
Audio products to be free of manufacturing defects in material and workmanship for a prescribed
period from the date of purchase (see specic warranty period on reverse). This warranty shall be
valid only if the product is purchased within the United States of America, including possessions
and territories. It is the owner’s responsibility to establish the date and place of purchase by ac-
ceptable evidence, at the time service is sought.
B. For warranty service you must obtain a Return Authorization number (RA#) before
sending back the product. Contact American DJ, Inc. Service Department at 800-322-6337. Send
the product only to the American DJ, Inc. factory. All shipping charges must be pre-paid. If the
requested repairs or service (including parts replacement) are within the terms of this warranty,
American DJ, Inc. will pay return shipping charges only to a designated point within the United
States. If the entire instrument is sent, it must be shipped in it’s original package. No accessories
should be shipped with the product. If any accessories are shipped with the product, American DJ,
Inc. shall have no liability whatsoever for loss of or damage to any such accessories, nor for the
safe return thereof.
C. This warranty is void if the serial number has been altered or removed; if the product is
modied in any manner which American DJ, Inc. concludes, after inspection, affects the reliability
of the product; if the product has been repaired or serviced by anyone other than the American DJ,
Inc. factory unless prior written authorization was issued to purchaser by American DJ, Inc.; if the
product is damaged because not properly maintained as set forth in the instruction manual.
D. This is not a service contract, and this warranty does not include maintenance, cleaning
or periodic check-up. During the period specied above, American DJ, Inc. will replace defec-
tive parts at its expense with new or refurbished parts, and will absorb all expenses for warranty
service and repair labor by reason of defects in material or workmanship. The sole responsibility
of American DJ, Inc. under this warranty shall be limited to the repair of the product, or replace-
ment thereof, including parts, at the sole discretion of American DJ. All products covered by this
warranty were manufactured after January 1, 1990, and bear identifying marks to that effect.
E. American DJ, Inc. reserves the right to make changes in design and/or improvements
upon its products without any obligation to include these changes in any products theretofore
manufactured. No warranty, whether expressed or implied, is given or made with respect to any
accessory supplied with products described above. Except to the extent prohibited by applicable
law, all implied warranties made by American DJ, Inc. in connection with this product, including
warranties of merchantability or tness, are limited in duration to the warranty period set forth
above. And no warranties, whether expressed or implied, including warranties of merchantability
or tness, shall apply to this product after said period has expired. The consumer’s and/or Dealer’s
sole remedy shall be such repair or replacement as is expressly provided above; and under no
circumstances shall American DJ, Inc. be liable for any loss or damage, direct or consequential,
arising out of the use of, or inability to use, this product.
This warranty is the only written warranty applicable to American DJ and American Audio
Products and supersedes all prior warranties and written descriptions of warranty terms and
conditions heretofore published.
MANUFACTURER’S LIMITED WARRANTY PERIODS:
• All American Audio Products = 1-year (365 day) Limited Warranty (except V-Plus Series Ampli-
ers)
• All American Audio V-Plus Series Ampliers = 3-year (1095 day) Limited Warranty
• American DJ Lighting and American DJ Branded Products = 1-year (365 day) Limited Warranty
(Such as: Special Effect Lighting, Intelligent Lighting, UV lighting, Strobes, Fog Machines, Bubble
Machines, Mirror Balls, Par Cans, Trussing, Lighting Stands etc. excluding Laser Products, lamps,
and Star Tec Series)
• American DJ Laser Products and Star Tec Products = 90-Day Limited Warranty
• American DJ L.E.D. Products = 3-year (1095 day) Limited Warranty (excluding motors which
have a 1-year (365 day Limited Warranty)

Technical Specifications:
Model: Mini Flame LED
Lamp: 40 LED’s; 14 Red, 22 Orange, &
4 Blue
Voltage*: 100v/230v ~ 60Hz /50Hz
Power Consumption: 10W
Dimensions: 6.5”(L) x 6.5”(W) x 4.7”(H)
Weight: 2.5Lbs./ 1Kgs.
Fuse: 1 Amp
Duty Cycle: None
Working Position: Any Safe position
Warranty: 3 Years (1095 days)
* Operating voltage is preset at the factory.
Please Note: Specications and improvements in the design of
this unit and this manual are subject to change without any prior
written notice.
©American DJ Supply®- www.americandj.com - Mini Flame LED Instruction Manual Page 7
©American DJ Supply
American DJ World Headquarters:
6122 S. Eastern Ave. Los Angeles, CA 90040 USA
Tel: [phone] / Fax: [phone]
Web: www.americandj.com / E-mail: [email protected]
American DJ Europe
Junostraat 2
6468 EW Kerkrade
Netherlands
[email protected] / www.americandjeurope.com
Tel: [phone] / Fax: [phone]