American Leather SHA BED User manual

SHA BED Installation
Quantity in Box: Prism Legs (4) Bolts (8) Washers (8) Screws (8)
Cylinder Leg (1) King Size Bed Only
This cylinder leg is
only used for the
King Size Bed
FIG. #1: Legs, bolts, washers and screws
provided.
BED FRAME
HEAD
BOARD
FIG. #2:Turn the bed over on its side as
shown.
FIG. #3: Open zipper on the bottom of
the bed to fasten bed platform to head
board.
FIG. #4: Make sure to install the bolts
on each opposite side at this location
first before installing the remaining bolts.
1
#100113
FIG. #5: Make sure to install the bolts
and washers to the location as
indicated by the arrows.
This cylinder center
leg is only used for the
King Size Bed
FIG. #6: Install each leg at the corner
(king will have 5th middle leg) with 2
wood screws before turning the bed
over.

Bed Disassembly Assembly Instructions
8-26-10

FIG 1. Located on each corner is a bracket. The bracket is attached to the rail and is
mounted to the headboard and footboard.
R
ai
l
Bracket
Headboard/Footboard

FIG 2.To separate the rail from the headboard/footboard pull up on the rail to unlock the bracket from
the headboard/footboard bracket. Repeat this on all other corners of the assembled bed

FIG 3. Once all corners have been unlocked the bed is broken down to two rails, footboard, and
headboard.
*Note: To assemble bed, reverse these directions.
Headboard
Rails
Footboard