AMERICH BRISA II 6644 User manual

Advise Americh when ordering to ensure there
are no issues with deck mounted controls.
Always take dimensions directly from the unit.
DIMENSIONS
66” x 44” x 26” (1676 x 1118 x 660 mm)
Whirlpool Operating Gallons = 90 (Liters = 341)
Gallon to Overflow = 100 (Liters = 379)
MATERIAL
Acrylic
Textured
UNDERMOUNT:
BRISA®II 6644
Yes
TUB FLOOR
STANDARD EQUIPMENT
• Adjustable Feet
30
35
44
9
12
66
1
12
57
44
2
38
Dia.
21
19
78
3
113°
113°
26
24
Americh products meet or exceed the following standards:
• Underwriters Laboratories (UL)
• Underwriters Laboratories - Canada (cUL)
• Canadian Standards Association - (CSA)
• ANSI Z124.1 • ANSI A112-19.7
• ANSI A112.19.8
Contact Americh for additional approvals.
APPROVALS & COMPLIANCE
All bathtub dimensions are ± 1/2” Last Update 08/25/20 Always check our website for the most updated specifications: Americh.com

Combination
(pump and blower location only)
Airbath System II Airbath System V
Jet
Suction
Rotary Jet
ON/OFF Control
Grab Bar
Access Panel
(Minimum 16” X 20”)
Light
BATHING SYSTEMS LEGEND
BRISA® II 6644
Label
OPTIONAL ACCESSORIES
ELECTRICAL REQUIREMENTS
INSTALLATION TIPS
(*) STANDARD ON PLATINUM SERIES
Last Update 08/25/20 Always check the website for the most updated specifications: Americh.com
Pump
Blower
Builder Series Luxury Series
Platinum Series
Americh recommends one 20 amp ground fault circuit
interrupter (GFCI) for each power supply provided
with the bathtub.
• ANEX (Americh Nanobubble Experience)
•Apron
- Flat Panel
- Removable Panel
• Chromatherapy
•Grab Bars: 9” - 14” - 16”
•High Density Insulation
•iBath Sound System
•Inline Heater (whirlpool only)
•Jets: Additional or Rotary
•Ozone System (whirlpool and/or Airbath only)
•Pillows: 12” - Angle
•Remote Control Upgrade (select series only)
•Serenity Soak (tub only)
•Thermal Comfort System
(TCS cannot be used with VSM)
•Trim Kit Upgrade
•Vibro Sonic Massage
(VSM cannot be used with TCS)
•Waste & Overflows Upgrades
-Cable Drive Waste & Overflow
-PVC Waste & Overflow
-Linear Waste & Overflow
1) Install according to Owner’s Manual and local codes.
2) Any tub with whirlpool, Airbath® or ANEX system requires an access
panel.
3) Hot water supply should be 65-75% of tub capacity or greater.
4) Cut Dimensions: 2” Smaller than Size of tub. It is recommended to wait for
unit to arrive before cutting.
5) Always consult your local plumber for recommendations as installations
will vary.
6) The combination of multiple systems and options may require
components to stick out and/or be remotely installed in the field.
7) All specifications are subject to change without notice.
• Certain options or altering the pump/blower location may cause the
pump/blower to extend beyond the tub decking.
• Factory installed aprons may increase the overall height of the tub
when ordered with certain accessories (ie. Linear Drain).
8) Center Drain tubs with Linear Drain option may not use 9” Grab Bar
option. Only the 14” or 16” Grab Bar option is available on these units.