AMERICH ETOILE 60 User manual

DIMENSIONS
60” diameter x 21” ( 1524 mm dia. x 533 mm)
Whirlpool Operating Gallons = 60 (Liters = 227)
Gallon to Overow = 86 (Liters = 325)
MATERIAL
Textured
UNDERMOUNT:
ETOILE®60
Yes
TUB FLOOR
STANDARD EQUIPMENT
• Adjustable Feet
• Advise Americh when ordering to ensure there are no
issues with deck mounted controls.
• Always take dimensions directly from the unit.
Acrylic
2
38
Dia.
3
14
78
16
60
52
11
12
19
21
36 1
12
121°
Americh products meet or exceed the following
standards:
• Underwriters Laboratories (UL)
• Underwriters Laboratories - Canada (cUL)
• Canadian Standards Association - (CSA)
• ANSI Z124.1 • ANSI A112-19.7
• ANSI A112.19.8
Contact Americh for additional approvals.
APPROVALS & COMPLIANCE
All bathtub dimensions are ± 1/2”
Last Update 4/1/22
Always check our website for the most updated specications: Americh.com

Builder Series Luxury Series
Platinum Series Combination
(pump and blower location only)
Airbath System II Airbath System V
Jet
Suction
Rotary Jet
ON/OFF Control
Grab Bar
Access Panel
(Minimum 16” X 20”)
Light
BATHING SYSTEMS LEGEND
ETOILE®60
OPTIONAL ACCESSORIES
ELECTRICAL REQUIREMENTS
Americh recommends one 20 amp ground fault
circuit interrupter (GFCI) for each power supply
provided with the bathtub.
INSTALLATION TIPS
• ANEX (Americh Nanobubble Experience)
• Chromatherapy
•Grab Bars: 9” - 14”- 16”
•High Density Insulation
•iBath Sound System
•Inline Heater (whirlpool only)
•Jets: Additional or Rotary
•Ozone System (whirlpool and/or Airbath only)
•Pillows: 12” - Angle
•Remote Control Upgrade (select series only)
•Serenity Soak (tub only)
•Thermal Comfort System
•Trim Kit Upgrade
•Waste & Overows Upgrades
-Cable Drive Waste & Overow
-PVC Waste & Overow
-Linear Waste & Overow
(*) STANDARD ON PLATINUM SERIES
Label
1) Install according to Owner’s Manual and local codes.
2) Any tub with whirlpool, Airbath® or ANEX system requires an access
panel.
3) Hot water supply should be 65-75% of tub capacity or greater.
4) Cut Dimensions: 2”Smaller than Size of tub. It is recommended to wait for
unit to arrive before cutting.
5) Always consult your local plumber for recommendations as installations
will vary.
6) The combination of multiple systems and options may require
components to stick out and/or be remotely installed in the eld.
7) All specications are subject to change without notice.
• Certain options or altering the pump/blower location may cause the
pump/blower to extend beyond the tub decking.
• Factory installed aprons may increase the overall height of the tub
when ordered with certain accessories (ie. Linear Drain).
8) Center Drain tubs with Linear Drain option may not use 9” Grab Bar
option. Only the 14” or 16”Grab Bar option is available on these units.
Pump
Blower
All bathtub dimensions are ± 1/2”
Last Update 4/1/22
Always check our website for the most updated specications: Americh.com