AmFab EZ Table 501 User manual

501 (LH) 502 (RH) EZ Table Assembly
PARTS LIST
1:
Top 15” x 30”
5:
1/4-20 Nut (N01)
2:
1/4 - 20 x 20” Bolt (BT10)
6:
Column (050007)
►► WARNINGS ◄◄
3
1/4 x 3/8 Zinc SMS Screw (SC12)
77
Base (Left 050037)
Base (Right 050036)
This Table is to be used with heavier chairs and couches.
4:
Trip Handle (101044)
8:
Top Bracket (101019)
Incorrect positioning of table base (#7) under the chair or couch may result in
the table tipping over. (Ref. Assembly step 1)
California Prop. 65
Warning: The items and packaging in this shipment contains
chemicals known to the state of California to cause cancer, birth
defects or other reproductive harm.
*This product meets or exceeds all federal safetyand environmental
regulations
Tools
►CAUTION--SPRING LOADED ASSEMBLY◄
Phillips screwdriver
Do not remove the black shipping screw before completing Assembly steps
1- 5. Removing the shipping screw before this can result in spring damage.
(2) 7/16” wrenches
ASSEMBLY INSTRUCTIONS
Product is NOT! to be used as a lift assist or to hold more than 25 lbs.
1
Place the base (#7) under the left side of chair with the magazine
rack opening facing the rear of chair. Place the front left leg of the
chair on the positioning pad (#8) located near the magazine rack.
2b
Stand the Column (#6) on end, making sure the Trip Rod is visible
in the rectangular tube but not protruding out of the top, as shown
in Fig. 1. If necessary, shake the Column (#6) until the rod drops.
3
Insert Trip Handle (#4) into the Column (#6) with the rounded side
up. Be sure that the Trip Handle (#4) rests on top of the rod inside
the Column foot (#6). Fig. 1
4
Place the Top (#1) on a flat surface, with the Top Bracket (#8)
facing upward. Then, while holding the Trip Handle (#4) in place
so it doesn’t fall out, insert the Column (#6) into the Top Bracket
(#8). Align the holes in the Column foot (#6), the Trip Handle (#4)
and the Top Bracket (#8). Install both bolts (#2) and both nuts (#5)
thru these aligned holes with the two (2) 7/16” wrenches. Fig. 2
!
!
!
!

5
Pick up the Top (#1) and Column (#6) and place over the round
tube on the Base (#7) inside of the magazine rack. Be sure the
Column (#6) has dropped down all the way!
6
Remove the black shipping screw in the column and replace it with
the zinc plated screw (#3), using a Phillips screwdriver. Fig. 3
OPERATION INSTRUCTIONS
A
To elevate the table, push upwards at any position on the underside of the top,until the top has reached
the desired height.
B
To lower, squeeze the trip handle up towards and push the top down to the desired height. The table
will operate best if the downward pressure is placed at the column end of the top
C
Occasional application of light oil lubrication between the inner and outer columns will help keep your
Over Bed Table operating smoothly. Penetrating oils with rust inhibitors are recommended.
D
The table will swing a full 360 degrees around on the base to be used as an end table or a lap tray as
needed.
!
Rev. B 03/03/16