AmFab TILT TOP OVER BED TABLE User manual

950 TILT TOP OVER BED TABLE
ASSEMBLY AND OPERATING INSTRUCTIONS
- !-1
PARTS LIST
TOOLS REQUIRED
1
Release Handle (101044)
8
Bolt Plate (101023)
9/16” WRENCHES
2
15 x 30 Table Top
9
3/8 –16 x 2 bolts (BT01)
PHILIPS SCREW DRIVER
3
Tilt Lock Lever (093025)
10
Casters (CA02)
California Prop 65
Warning: The items and packaging in this
shipment contain chemicals known to the
state of California to cause cancer, birth
defects or other reproductive harm.
*This product meets or exceeds all federal
safety and environmental regulations.
4
3/8 -16 x 2 ¼bolt (BT05)
11
Top Bracket (093008)
5
3/8-16 Lock Nut (N06)
12
Black Shipping Screw
6
Column Assembly (95001)
13
Zinc Screw (do not remove)
(SC12)
7
Base with Caster Plugs
ASSEMBLY INSTRUCTIONS
1
Lay tabletop Assembly (#2 &#11) on workbench or floor with top bracket assembly facing up,
as shown in Fig. 2.
2
Install column assembly into top bracket as shown with release handle facing away fro table
top edge (fig. 2). Insert 2 ¼” bolt (#4) through top bracket and column assemblies. Fasten
with locknut (#5)
3
Lay the base flat with holes facing up and insert a caster (#10) into each hole. (4 casters total)
4
Place the two bolts (#9) into the bolt plate (#8) and place through the base (#7). Hold base
steady while hand tightening bolts (#9) into column (#6).
5
Align the base and top assembly by laying the table on its side, resting on the edge of the top
and the black caster plugs. Tighten the bolts (#9) with a 9/16” wrench.
"
Fig1
"
G:\Amfab1\Public\Instruction_Sheets\950 instructions.doc

950 TILT TOP OVER BED TABLE
ASSEMBLY AND OPERATING INSTRUCTIONS
- !-2
6
Stand the table up on its casters.
7
Remove black lock screw in the column and discard. Replace with the extra zinc plated screw
shipped with unit, using a Phillips screwdriver.
OPERATING INSTRUCTIONS
1
Pull the release handle (#1) up to raise and lower the tabletop.
Fig. 2
2
To tilt the tabletop in either direction, squeeze the tilt lock lever (#3) up and rotate the
tabletop. Release Tilt Lever to lock the top into place. Rev.B 03/03/16
G:\Amfab1\Public\Instruction_Sheets\950 instructions.doc