Amico Freedom Series User manual

Corporation
Installation Instructions
Surface Mounted
Freedom Series Panel Wall

Note
The installation instructions provided are for the Amico standard products. Slight modications
to the installations may be required. The product shipped to the job site may not be exactly as
shown on the installation drawings.
Panel wall installation should conform to local building codes.
Figure 1
2Amico Architectural
Before Installation
1. Review a copy of the nal approved shop drawing(s) and/or submittal package. These docu-
ments will provide you with technical information specic to your installation, such as:
• equipment types and quantities
• room numbers and location
• shop drawings of each unit type
• wiring diagrams and rough-in locations
2. Locate the panel wall unit from the shipping boxes that you wish to install. The contents of each
shipping box are listed on the shipping document(s). Product is shipped in multiple sections,
please see picture below for references. (Figure 1)

1. Mark the horizontal line for the mounting bracket: 7”below ceiling line. This line will be used to
locate drilling for mounting of hanging bracket. (see Figure 2) Mounting bracket is one piece for
all sections, please see Figure 3.
Figure 2
Figure 3
7” below
finish ceiling
www.amico.com 3
Installation

4Amico Architectural
Installation
2. Align bracket horizontally according with headwall mounting location. Refer to drawings. Mount
bracket to the wall using hardware compliant to local building codes (supplied by others). En-
sure hanging bracket is secured to the wall studs or blocking behind the drywall (see Figure 4)
Figure 4

3. Prepare units to be hang over the mounting bracket
a. Headwall will be delivered in multiple sections, please see approved drawings for exact
number ( see Figure 5 for references only)
Figure 5
www.amico.com 5
Installation

b. Remove laminate panels located at the top section and bottom sections, where applicable. (Figure 6)
c. Hang all units in place and make sure the bottom line up for all sections.
d. Secure units through lower rear bracket to wall, where applicable. (Figure 7)
e. Secure each section to each other using the hardware provided by Amico. See Figure 8 for details.
Figure 6 Figure 7
Figure 8
6Amico Architectural

www.amico.com 7
Other Installation Notes
4. Make all med gas and electrical connections.

C US LISTED
Amico Architectural | www.amico.com
85 Fulton Way, Richmond Hill
Ontario, L4B 2N4, Canada
71 East Industry Court, Deer Park
NY 11729, U.S.A
Toll Free Tel: [phone]
Toll Free Fax: [phone]
Tel: [phone]
Fax: [phone]
Email: [e-mail] INSTALL INSTR. FS PNL WL SRF MNT 2012
www.amico.com