AMobile K430 User manual

Mobile Computing Device
with Keyboard
Quick Start Guide
Package Content
•1 x K430
•1 x Lithium Battery
•1 x Quick Start Guide
Front View
Cursor Left
key
Scan Key
Cursor Right
Key
Input Mode Switch
(Lowercase /
uppercase /
numeric mode)
Capital Letter
Lock Key
Microphone
Touch
Screen
Scan LED
Receiver
Proximity
Sensor
Charging LED
Function Key
Function
key Switch
(F1~F10)
Power Key
Overview Overview Installation
The K430 comes with a Lithium battery in the packing box. Before
installing the battery, it's suggested that you install the Micro SIM/
microSD card first as described below.
1. Make sure to use the battery provided with the K430.
Using a wrong battery may result in a risk of explosion.
2. Before installing the battery, make sure all the
components are dry. Using wet components may
cause damage not covered by the warranty.
1. Turn off the K430. Move the battery cover lock button to the
unlock position at right.
2. Gently pry off the battery cover from the grooves on the sides.
-1- -2- -3-
Rear View/Side View
Camera &
Flash LED
Battery Cover
Lock
Speaker
Handstrap
Buckle
Scan Engine
Handstrap
Buckle
USB Cover
Charging
Contact
NFC
Sensor
Area
Battery
Cover
Scan
Key
Charging
Contact

Charging Via a Computer
1. Open the USB cover on the bottom side of the K430 to reveal
the micro USB connector.
2. Using the provided USB cable, connect the K430 to your
computer.
打开USB盖
Open the USB cover
Charging via AC Power
1. Open the USB cover on the bottom side of the K430 to reveal
the micro USB connector.
2. Using the provided USB cable, connect the K430 to the provided
power charger.
3. Connect the power charger to charge the K430.
打开USB盖
Open the
USB cover
Using the battery and charger not provided with
the K430 may result in damage not covered by the
warranty.
Turning On/Off the K430
1. To turn on the K430, long press the Power key for 3 seconds.
2. To turn off the K430, press the Power key for 1 second and then
a power menu will pop up.
Sleeping/Awakening Mode
1. When the screen is on, press the Power key to put the K430 into
sleep mode.
2. When the screen is off, press the Power key to wake up the K430.
Resetting
If the system stops responding, long press the Power key for about
15 seconds and release to reset the K430.
Power LED
Status LED Description
Non-
charging
Flashing Red Battery power is below 15%
No LED Battery power is above 15%
Flashing Green Incoming call, message or notification
Charging Solid Red Battery power is 0-99%
Flashing Green Battery power is 100%
Notice
1. Do not use or charge the device in dusty or damp places.
Otherwise, the circuit may not function properly。
2. Do not place the device near heater or other sources of heat.
3. Keep the ambient temperature between -10ºC~ 45ºC and rela-
tive humidity between 10%～90%RH for using the device.
Installation Charging Turning On/Off
3. Follow the direction arrows to unlock the card slot cover(s) and
open the cover(s).
4. Insert your SIM/microSD card and close the cover. Follow the
direction arrows to lock the card slot cover(s).
解锁方向
Micro SIM卡槽
Micro SIM卡槽
T-Flash卡槽
锁定方向
microSD card slot
Micro SIM card slot
Unlock the cover Lock the cover
Micro SIM card slot
1. There is no specific order of the two SIM card slots.
You can make the configurations as required in the
system.
2. Make sure to use standard Micro SIM/microSD card.
Using non-standard cards may cause damage not
covered by the warranty.
5. Insert the battery. Please insert the connector side first, and then
press the battery down.
6. Replace the battery cover. Move the battery cover lock button to
the lock position.
-5--4- -6-