AMSTRAD AMVC203 User manual

※ Components
1
Hand grip
Charger
Main body
Handheld vac
Crevice tool
Sweeper
Water container
Mop

※ Before first time using
※ How to Charge
1 2 3
Insert the hand
grip into the body
1put the handheld vac into
the body then charge
2Handheld vac be charged individually
insert the body
into the sweeper
put the handheld
vac into the body
4insert the crevice
tool into the body
2

When using if the the blue light blinks in 1 HZ frequency,it indicates battery
power is low, it need to charge.
1.Press once on the switch on the hand grip to stop the machine.
2.Connnect the plug of charger to the electric supply
3.Connect the another end of charger to the battery pack inside of the main
body through DC hole
4.The blue light blinks in 1 HZ frequency, which indicates charging normally.
5.The blue light on, which indicates the battery is fully charged.
6.Unplug the charger and put aside
7. Handheld Vac can be charged when it is in the main body or get it out to
charge
△Caution：
Do not put water into the charge hole of the main body, or the product will fail in
function.
Do not charge or store the product below 0℃ or above 40℃, otherwise it will
affect the function
When charging, the charge temperature may rise, it is normal phenomenon
※ How to use? (For the handheld Vac)
3
Turn on or Turn off
Press this button, get
the handheld vac out
Assemble the crevice tool into the body
1 2
3
4
the handheld vac works

4
※ How to use? （The main body+ Handheld Vac）
※ How to use? （The mop function）
Press it once, the product turned on and sweeper light on.
Press it twice, the product turned on and LED light on,
the sweeper start to work.
When handheld vac assembled in the main body, the
switch have no function
Step on this buttun,
water in the tank
can moisten the mop
This hole is for
adding water
Assemble the water
tank into the machine

5
※ How to use? （Emptying the dirt container）
press this button
1 2
3 4
get the dust container out
get the filter out Emptying the dirt container
※ How to use? （Cleaning）
1get the filter and support out 2clean the filter and the support
(washable)
3Get the brush wheel out 4clean the brush wheel
if there are hairs in the brush wheel, disassemble
the pole out, and use a knife to cut the fair
through the groove and clean the pole

6
△Caution：
1. The machine is applied to use indoors only, please kindly read the instruction
manual before using it.
2. This machine is applied to clean flat hard floor and short hair carpet instead
of using on uneven surfaces.
3. Suitable to clean less than 10mm dust.
4. For dry pick up only, Do not pick up flammable or combustible materials
(lighter fluid, gasoline, kerosene,etc.) or use in the presence of explosive liquids
and vapor.
5. When the handheld vac is out of the main product, do no turn on the
machine, in case of inhaling dust ruined the fan.
6. When the battery is low till no power, recharge it after 30min rest to protect
the battery, expend the using life.
※ Make sure the product is turned off when maintenance and care of the
product.
※ Do not soak the machine into water when cleaning.
※ Use clean and soft cloth with water or detergent to wipe the product.
※ Do not clean the product with gasoline,alcohol, rubber glue or other intense
detergent.
7. Each time after using this product, get the wet mop out of the machine, clean
and dry it for storage.
8. Storage the clean product and spare parts in a cool dry place.
9.If the product stock over 6 month no used. pls discharge then recharge again.
10. Discharge and recharge thrice,can keep the motor and battery good
condition.
※ How to change the battery?
1Unscrew the screw on
the buttom of the machine
2get the cap out 3get the battery out

7
Troubleshooting Guide
Please read this manual and check the following points carefully before
bring the appliance to customer service
■Product specification
Power Supply：Rechargeable Battery
Input Voltage：AC100-240V 50/60Hz
Rated Output Voltage: 17.5VDC,650mA
Battery Capacity: Li-ion 14.4V 2000mAh
Charging Time: 3.5Hours
Continuously Working Time: About 20 minutes
Suction power: 2.4-3.0KPa
Dust capacity: 0.6L
Product size: 1135*265*190mm
Product weight: About 3400g
Problem Possible reason Possible solution
battery capacity
deterioration
battery power
is inefficiency
recharging
malfunction
recharge required
Please contact dealer
please contact dealer to
replace the battery
indication light flash with
5Hz frequence while
recharging
Indication light
with 5Hz frequence
main brushes
is entangled cleaning the main brush
Indication light
with 5Hz frequence
Battery with high
termperature protection
Stop work can keep
it cool down
working hours' getting
shorter after usage
indication light with 3Hz
frequence last 30
seconds while working