10
3
1
5
6
817
19
18
4
2
15
12
13
7
14
9
16
11
BAND
TIME/
PROG.
REP./
MO/ST
1. POWER BUTTON
2. BAND BUTTON
3. RANDOM BUTTON
4. P-UP BUTTON
5. BACK BUTTON
6. FUNCTION BUTTON
7. PLAY/PAUSE BUTTON
8. P-DOWN BUTTON
9. NUMBER KEY
10. MUTE BUTTON
11. INTRO BUTTON
12. TIME/PROGRAM BUTTON
13. REPEAT/MO/ST BUTTON
14. EQ BUTTON
15. NEXT BUTTON
16. STOP BUTTON
17. BBS BUTTON
18. VOL+ BUTTON
19. VOL- BUTTON
to setup the time of the unit
1.Connect the ac on( .
2.
3.
4.Press time button to confirm.
5.Then you can set the hour and the minute with the same method of steps 3-4.
The following operation must be in standby mode)
short according to the time button, the time will flashing on the lcd display.
Press BACK、NEXT to select the number of the time. You can setup the time format
by 12h or 24h.
after setup the unit time, long press the time button can setup the unit begin working
time ,with the same method of steps 3-4.
Note: after setup the beginning time, the lcd will display the radio/cd/usb/aux mode,
Press the BACK or NEXT to choose the mode, then it press time button to affirm,
otherwise it play usb or aux mode first.
RADIO
Radio reception
1.Press FUNCTION button select RADIO mode.
2. Press BAND to select the desired wave band: AM, FM, FM ST.
3.Tune to required station by press BACK、NEXT or PRE-UP、PRE-DN button.
Manual Tuning: Press BACK or NEXT button and then release within 1 sec.
Auto Tuning: Press the PLAY/PAUSE button enter the automatic channel surfing
mode, and to be put automatically sets.
reset Channel:(FM 30 Preset memories, A )
(1) Press BACK or NEXT button to select desired station.
(2) Press PROGRAM button once , The MEMORY number indicator begins fixed in
the display.
(3) Press PRESET-UP OR PRESET DOWN buttons to select the desired number.
(4) Press PROGRAM button to save that station.
(5) Repeat steps (1) to (4) procedures for other stations.
4.After end of program. Press PRE-UP or PRE-DN to start play the frequency that you
selected or press number key on the remote control .
5.Rotate [VOL-]or [VOL +] to adjust the volume.
6.Extend TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting.
7. Turn off the radio by pressing the FUNCTION button select another mode or press
the power button to turn off the unit.
8. The memory frequency still exists , after switching back on the unit.
MONO/STEREO
- Press MO/ST button once to mono state;
- Press MO/ST button twice to stereo, stereo is displayed.
M 10 Preset memories
