andrews HPAC 30 Product information sheet

andrews-sykes.com
Operating Instructions
& Safety Guide
General Safety
Electrical Safety
0800 211 611
This equipment should only be used by a competent
person who has read and understood these instructions.
Check condition of equipment before use. If unit is
showing any signs of damage contact your supplier
immediately.
Never operate this equipment if you are ill, feeling tired or
under the inuence of alcohol or drugs.
Keep all vents and grills clear of obstructions.
Keep children and animals away from electric powered
equipment. Never leave them alone when the unit is in
use.
Make sure equipment is switched o and unplugged after
use.
This unit operates on a 415 volt 5pin 32amp power supply
The power cable must be a minimum of 6mm2 up to a
maximum length of 40 meters. All cables over 40 meters will
require a larger C.S.A of cable.
Always inspect plugs and power cables for damage before
plugging into power supply.
DO NOT USE IF ANY DAMAGE IS FOUND.
If an extension lead is used, ensure it is of the
correct standard and fully uncoiled before use.
Cables must not be laid in wet or damp areas.
Do not move equipment while operating.
Getting started and operation
Position equipment on level ground.
Position away from any materials that can
be drawn into the air intake grill.
Do not use within any zoned or hazardous
areas.
Do not position unit inside of any
building or temporary structure
Keep at least 1 meter of clearance around
the unit and don't restrict the air flow
around the chiller
The HPAC 30 unit can only be controlled
on outlet Air and not inlet Air
Fig 1
5 pin 32amp 415 volt Appliance inlet
plug found on the HPAC 30
HPAC 30
Cooling model Only
Fig 1
Fig 1

Fig 5:
Carel 4 button controller.
Cooling is selected through the
controller Main isolating switch
for power isolation
Fig 6:
Normal running conditions will
have the outlet Air temperature
displayed on the controller and
the condensing fan motors on
top of unit will only run when
the unit needs to remove the
heat from the condensing coil
Fig 2 :
Connect the outlet Air Ducting
to the top spigot 450mm
Connect the inlet Air Ducting to
the bottom spigot 450mm
Fig 3 :
When the electrical supply is
connected and turned on, the
phase rotation must be
checked inside the electrical
panel. Yellow light indicates
correct phase rotation.
If phase rotation is incorrect
then the controller 3CF1 will
not light up and the unit will
not work
Fig 4:
Fan Speed Controller
Switch. This switch must be
turned to max speed when
ducting is connected to
improve airflow
Fig 5: Control panel
Fig 2
Fig 3 Fig 4
Fig 6
Please note that the product in this photo is an older model.