andrews PAC14 Series 5 QC Product information sheet

PAC 14 Series 5 QC
Air conditioning
Operating Instructions
& Safety Guide
General Safety
Electrical Safety
This equipment should only be used by a competent person
who has read and understood these instructions
Check condition of equipment before use. If unit is
showing any signs of damage contact your supplier
immediately
Never operate this equipment if you are ill, feeling tired or
under the influence of alcohol or drugs
Keep all vents and grilles clear of obstructions
Keep children and animals away from air conditioning
units
Never leave them alone in room where the units in use.
Make sure equipment is switched off and unplugged after
use.
This unit requires a 230 volt electrical supply. It plugs
into standard domestic BS1363 13 amp socket
Always inspect plugs and power cables for damage before
plugging into power supply
DO NOT USE IF ANY DAMAGE IS
FOUND
Ensure cables are installed so as not to cause a hazard
If an extension lead is used, ensure it is of the correct
standard and fully uncoiled before use
Cables must not be laid in wet or damp areas
Do not move equipment while operating
Do not pull equipment by the power lead
It is recommended that this equipment is protected by an
RCD when in use.
Getting started and operation
The unit consists of the indoor cooling unit and an
external heat exchange unit. The external heat
exchanger must be positioned outside the area to be
cooled, either by hanging the external unit out of a
widow (fig1) or for more permanent/ long term
applications, disconnecting the refrigerant flexible
lines from the room unit and passing through a
100mm diameter hole in the wall and reconnecting.
Always use 2 spanners to avoid damaging the
copper pipework. (fig2).
Fig 1

If disconnecting and reconnecting the refrigerant lines, cover the
ends of the couplings with a plastic bag to avoid getting any
contamination / grit in the couplings.
Never operate the unit in very hot or cold conditions – it works
properly at temperatures between 16 and 30oC
Always allow the unit to stand/settle for 5 minutes before switching
on when either setting or restarting
Position the mobile air conditioner in a flat location where the air
outlets cannot be covered up. Place the unit no less than 20cm away
from a wall or other obstacles
Connect to suitable 230 volt electrical supply. If using extension
cables, make sure they are of the correct cable size and always un-
coil fully from the cable drum.
Fig 2
1. Power On/off Button
2. Mode Button (fan speed mode)
3. LED Auto fan speed
4. LED Hi fan speed
5. LED Med fan speed
6. LED Lo fan speed
7. LED Dehumidifying mode
8. LED Fan only mode
9. LED Compressor running mode
10. Temperature setting buttons
11. Display shows the nominal set temperature or the residual
time of a programed time
12. On / Off timer. The timer function can be used to switch
the unit
On or Off automatically at hourly intervals.
13. LED timing On / Off
14. Auto swing button
15. LED manual water drain required
16. Infrared receiver. Receives signals from the remote control 1. Power On / Off
2. Mode selection button
3. Temperature set buttons
4. Louver swing button
5. Timer set
6. Fan only button
Controls
Remote Control
3
2
1
4
5
6