Angelo Decor AD93640W User manual

Renaissance Fountain AD93640W
Thank you for buying an Angelo Décor Fountain!
We hope you will find these instructions helpful in setting up your fountain.
If you have any issues with this item, please DO NOT return the unit to place of purchase.
Please visit our web site, www.angelodecor.com, for assistance and warranty information.
First unpack carton carefully, arranging parts safely in your working area.
Arrange all pieces in your
workspace. Pass the power cord down the
cord pipe in the large bowl. Carefully rest the bowl on its side.
Feed the pump cord down the
pedestal and out the base.
Align the pump cord with
the groove at the base of
the pedestal.
Carefully lower the bowl on to
the pedestal. Align the
grooves, then twist and lock it
The pump is preset to full
strength. If splash is a
concern, adjust as needed.
Install the cord pipe cover
by aligning the cord then
fitting it in to the pipe.
The pump should sit flat
inside the bowl as shown
above. Attach the included
Now simply fill with clean water and plug into a grounded GFCI outlet.
We recommend keeping bowl 3/4 full of water to avoid pump burnout.
Product must be properly stored for winter.
The final assembly
should look like this
Arrange all pieces in your
workspace. Pass the power cord down the
cord pipe in the large bowl. Carefully rest the bowl on its side.
Feed the pump cord down the
pedestal and out the base.
Align the pump cord with
the groove at the base of
the pedestal.
Carefully lower the bowl on to
the pedestal. Align the
grooves, then twist and lock it
to the pedestal.
The pump is preset to full
strength. If splash is a
concern, adjust as needed.
Install the cord pipe cover
by aligning the cord then
fitting it in to the pipe.
The pump should sit flat
inside the bowl as shown
above. Attach the included
tubing to the pump.
Set the pump housing /
riser in to place, align the
grooves then twist and lock
it to the bowl.
Feed the tubing up the pump
housing / riser and pass it
through the middle of the
small bowl.
Align the grooves then
lower and twist and lock
the small bowl to the riser.
Connect the tubing to the
top.
Align the top then lower and
secure it to the small bowl.
Check to ensure the
tubing is still properly
attached to the pump
and install the pump
access door. This
feature makes it
easier for you to
clean and adjust your
pump.