anko QL-5903A User manual

Mini Hair dryer
QL-5903A
User Manual
PLEASE READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE

IMPORTANT SAFEGUARDS
When using any electrical product, always follow these basic safety precautions:
READ ALL INSTRUCTIONS BEFORE USE.
Please read this instruction manual before using your product and keep it in a safe place for
future reference. If you pass the appliance on to anyone else, please include this manual.
•Carefully read all instructions before operation and retain for future reference.
•Do not place near the edge of a bench or table during operation.
•Ensure the surface is dry, level, clean and free of liquid and other substances.
•Do not leave the appliance unattended when in use. Always ensure the appliance is
turned off by switching off and unplugging the appliance when not in use, if left
unattended and before cleaning and storing.
•Always keep the appliance clean.
•Fully unwind the cord before use.
•To protect against electric shock, do not immerse the power cord, plug or appliance in
water or any other liquid.
•Do not allow the cord to hang over the edge of the table or bench, touch hot surfaces
or become knotted.
•This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance bya
person responsible for their safety.
•Children should be supervised to ensure that they do not play with this appliance.
•If the supply cord is damaged, it must be replaced by a qualified electrician in order
to avoid a hazard, or the product must be disposed of.
•This product is intended for household use only. Do not use it outdoors or
use for commercial purposes.
•NEVER grasp the appliance, power cable or power plug with wet hands.
•Always remove the power cable from the socket by pulling on the plug, do not pullon
the cable itself. Do not carry or lift the appliance with the power cord.
•Do not fold or crush the power cable. Ensure that the power cable does not run over
sharp edges.
•Please do not attempt to dismantle the appliance. This appliance has no user-
serviceable parts inside.
•When the appliance is used in a bathroom, disconnect from the mains power after
use. Since the proximity of water presents a hazard even when the appliance is
switched off.
•Do not use outdoors or operate where aerosol (spray) products are being usedor
where oxygen is being administered.
•For additional protection, the installation of a residual current device (RCD/Safety
switch) having a rated residual operating current not exceeding 30mA is advisable in the
electrical circuit supplying the bathroom. If unsure, check with your electrician.
•DANGER OF ELECTRIC SHOCK! Do not insert any foreign objects into theappliance.
•Do not use any accessories not supplied with this product.

•The appliance is not intended to be operated by means of an external timer or
separate remote control system.
•Always keep the hair away from the rear grille of the appliance. Hair may be sucked
into the rear of the appliance causing a blockage.
•Never cover or block the rear grille of the appliance. This may lead to overheating. If
the rear grille becomes blocked, stop using the appliance immediately.
•Ensure the appliance concentrator nozzle is free to blockages. Unrestricted airflowis
required for correct operation and to prevent overheating.
•The concentrator nozzle will become hot is use. Allow it to cool before removing it.
•For cleaning, please refer to section “CLEANING AND MAINTENANCE”
•For what action to be taken to adjust the appliance, please refer to section “SETTING
THE MAINS VOLTAGE”
RISK OF FIRE
•Do not leave the appliance unattended when in use.
•To avoid a build-up of heat, NEVER cover the appliance. Do not use the appliance
under a blanket or at other poorly ventilated locations
•Avoid the addition of heat from other sources, e.g., from direct sunlight, heating
appliances, other devices, etc.
•Do not use an extension cable. In the event of danger, the plug must be quicklyand
easily accessible.
ELECTRICAL REQUIREMENT
•Check that the voltage on the rating plate of your appliance corresponds withyour
house electricity supply which must be 110-120V or 220V-240V AC.
•For Australia the Voltage Selector (4) must be set to 220-240V AC.
IMPORTANT
•The plug removed from the mains lead, if severed, must be destroyed as a plug with
bared flexible cord is hazardous if engaged into a live socket.
•If the supply cord is damaged DO NOT use. For electrical safety, any repairs to the
product must becarried out by qualified electrical person only or the product must
be disposed of.
Danger of suffocation! Keep all packaging material away from children.
Dispose of the packaging materials in an appropriate way. Contact your
local authorities about collection points or waste separation.
Caution Risk of Burning! The appliance gets very hot!
Take care to avoid contact between the hot surfaces of the unit and the
skin, paying particular attention to the face, neck and hands
WARNING: Do not use this appliance near bathtubs, showers, basins or
other vessels containing water.
Class II Appliance.
The hairdryer is for household use only.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE

INTRODUCTION
Use this appliance to dry human hair only. Do not use this appliance on artificial hair or
animals. The appliance may have different results depending on the hair type. Therefore, we
recommend to do a trial at a hidden spot before first use. The hairdryer is not recommended
for damaged or bleached hair.
PARTS
1. Air outlet
2. Rear grille/Air inlet
3. Foldable Handle
4. Voltage selector
5. Power/Speed switch
6. hanging loop
7. concentrator
BEFORE FIRST USE
•After unpacking the appliance, check for transport damage and that all the parts
mentioned in this manual are present. In the event of damaged or missing parts,return
the product back to Kmart.
•Do not discard the original box. It can be used for storage and dispatch toavoid
transport damage.
•Clean the appliance as described in CLEANING AND MAINTENANCE. For your safety
makeparticular attention to the IMPORTANT SAFEGUARDS supplied in the user
manual.
•For Australia the Voltage Selector (4) must be set to 220-240V AC.
1
3
4
2
5
7
6

SETTING THE MAINS VOLTAGE
Always check the local mains voltage in your area before connecting this appliance.
You may need to change the voltage selector setting to match the local mains voltage
correctly. To change the operating voltage, turn the selector switch on the handle with a
screwdriver or a small coin to line up the slot in the screw with the correct voltage as shown
below:
IMPORTANT! Always remember to check the voltage setting before use when you have
travelled to another country or returned home. Incorrect voltage setting will result in
permanent damage to the appliance
For Australia, ensure that the Voltage Selector (4) is set to 220-240V AC.
OPERATION
•Fully unwind the mains cable. Make sure the Power/ Speed switch (5) is in OFF (0)
position.
•Place the appliance on a smooth, flat, dry surface. Plug-in and switch on at the mains
supply.
•Fit the Concentrator if required by pressing it firmly into the Air Outlet.
•The Concentrator can be dis-assembled if not required, but allow it to cool before
removing.
•Adjust to the desired blowing strength:
Position O ------ OFF
Position ------ Low heat setting
Position ------ High heat setting
•When finished drying or styling, switch the appliance OFF, unplug the applianceand
allow it to cool before putting it down/storing.
CLEAN THE REAR GRILLE
•If during use, the rear grille becomes clogged or blocked with dust or dirt, clean the rear
grille.
•Remove dust or dirt by using a dry brush.
•The unit should be cleaned at least once a month.
•Clean the appliance with a soft, slightly damp cloth. Make sure that no moisture has
entered the appliance during cleaning.
CLEANING AND MAINTENANCE
•Attention! Turn off the appliance and disconnect the plug from the
power outlet before cleaning.
•Attention! Do not use any alcohol, acetone, gasoline, abrasive cleaning agents, etc.to
clean the plastic components. Do not use hard brushes or metal objects forcleaning.
•Risk of burning! Do not clean the appliance while still hot.
•Clean the appliance with a soft, slightly damp cloth. Make sure that no moisture has
entered the appliance during cleaning.
•Never submerge the appliance in water or let water run over the heating element or
appliance.
•Clean the air inlet from time to time with a fine brush.

STORAGE
•Store the appliance in a cool, dry location, away from children and pets.
•If the appliance is not used for an extended period, store it preferably in itsoriginal
packaging.
•After use do not wrap the cord around the appliance as this may cause the cordto
fracture. Coil cord loosely by the side of the appliance in storage.
DISPOSAL
•Do not dispose this product with normal household waste collection. If unsure, contact
the local council waste management service for proper disposal facilities available for
your area.
TECHNICAL DATA
Voltage: 110-120V or 220-240V
Frequency: 50-60Hz
Power: 1000-1200W

12 Month Warranty
Thank you for your purchase.
Your new product is warrantied to be free from defects in materials and workmanship for the period stated
above, from the date of purchase, provided that the product is used in accordance with accompanying
recommendations or instructions where provided. This warranty is in addition to your rights under the
Australian Consumer Law.
For New Zealand customers, this warranty is in addition to statutory rights observed under New Zealand
legislation.
We will provide you with your choice of a refund, repair (where possible) or exchange (availability
dependent) for this product if it becomes defective within the warranty period. The business will bear the
reasonable expense of claiming the warranty.
This warranty will no longer apply where the defect is a result of alteration, accident, misuse, abuse or
neglect.
Please retain your receipt as proof of purchase and contact our Customer Service Centre as listed below, for
the entity you purchased this product from, for any difficulties with your product. Warranty claims and
claims for expense incurred in returning this product can be addressed to the respective Customer Service
Centre.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail
to be of acceptable quality and the failure does not amount to a major failure.
Contact for Kmart purchases
Contact for Target purchases
Kmart Australia Ltd.
C/- Customer Service Centre
690 Springvale Road,
Mulgrave Vic 3170
Customer Service: 1800 124 125
(Australia) or 0800 945 995
(New Zealand) or via
Customer Help at kmart.com.au
Target Australia Pty Ltd
C/- Customer Service Centre
2 Kendall Street, Williams Landing,
Vic, 3027
Customer Service: 1300 753 567
or via Customer Help at
target.com.au/help/contact-us