AnyDATA AWR-500A User manual

AnyDATA.NET
Wireless Wi-Fi Router, AWR-500A
(User Manual)
V 1.5
2008.07.25

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™2/38
AnyDATA CDMA Module Series Reference Design Specification
Copyright © 2008 AnyDATA Corp. All Rights Reserved.
Any part of this document may not be distributed, communicated, reproduced or transmitted in any form
or by any means, electronic or mechanical or otherwise, for any purpose, without the permission of
AnyDATA Corp.
This document can be subjected to revision without further notice.
Contact Address
AnyData.Net Inc.(Korea)
DaeGo Bldg, 8 th., 1591-10
Kwanyang-dong, Dongan_gu,
Anyang City, Kyunggi-do Korea.
http://www.anydata.co.kr
e-mail: [email protected]
Rep:[phone]
Fax:[phone]

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™3/38
Contents
1. Introduction................................................................................................................................................4
1.1 Feature.................................................................................................................................................4
1.2 Front & Back view................................................................................................................................5
1.3 Antenna Insatallation ...........................................................................................................................6
2. Package Contents .....................................................................................................................................7
3. Using the Configuration Menu...................................................................................................................8
User Login..............................................................................................................................................8
Setup Wizard > CDMA Dial-Up Setting..................................................................................................9
Setup Wizard > Host Setting................................................................................................................10
Setup Wizard > Time Zone .................................................................................................................. 11
Advanced Setup > System > System Status .......................................................................................13
Advanced Setup > System > Gateway Name Config ..........................................................................14
Advanced Setup > System > Time Zone .............................................................................................15
Advanced Setup > System > ROUTER firmware Upgrade .................................................................16
Advanced Setup > System > Client Information ..................................................................................17
Advanced Setup > System > Remote Admin.......................................................................................18
Advanced Setup > System > Password Settings ................................................................................19
Advanced Setup > System > Reset.....................................................................................................20
Advanced Setup > System > Factory default.......................................................................................21
Advanced Setup > CDMA > Dial Up Setting ........................................................................................22
Advanced Setup > CDMA > Your DNS ................................................................................................23
Advanced Setup > CDMA > Reconnect Settings.................................................................................24
Advanced Setup > Wireless LAN > Wireless Setting ..........................................................................26
Advanced Setup > Wireless LAN > Security........................................................................................27
Advanced Setup > Firewall > Firewall Setting .....................................................................................28
Advanced Setup > Firewall > Client Filtering.......................................................................................29
Advanced Setup > Firewall > MAC Control .........................................................................................30
Advanced Setup > NAT........................................................................................................................31
Advanced Setup > NAT > Virtual Server..............................................................................................32
Advanced Setup > NAT > Port Mapping ..............................................................................................33
4. Troubleshooting.......................................................................................................................................35
5. Technical Specifications ..........................................................................................................................37

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™4/38
Thank You for Purchasing the “AWR-500A”
1. Introduction
1.1 Feature
- The AWR-500A CDMA 1x EV-DO IP Router supports the WLAN 802.11 b/g standard providing
constant 54Mbps data rates which are proven and secure technology.
- The AWR-500A combines the advanced CDMA EV-DO technique with the mature WAP technique
together to provide one completely feasible, secure high-performance wireless network infrastructure.
- Wireless broadband connectivity and universal compatibility with a 1x EV-DO module with tethered
data capability enables you to set up a WiFi hotspot virtually anywhere.
- Support 4 ports switching hub as LAN connection, Wireless up to 253 PC users
- High-speed data connections with rate up to 3.1Mbps
- NAT & NAPT Virtual Server
- Automatic receipt of IP address with DHCP server
- 4 Indicator LED for Power, WAN (1x EV-DO), WLAN, LAN
- Browser-based configuration and easy set-up wizard
- Access Control to manage users
- User-friendly configuration and diagnostic utilities
- Industry-leading firewall security
- Supports 802.11 b/g Access Points, Routers and Gateway Server Applications

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™5/38
1.2 Front & Back view
①②③ ④
⑤ ⑤
⑥ ⑦ ⑧
1) Power LED: A red light indicates connection to the power supply
2) WAN LED: A red light indicates that connection on the EV-DO port.
3) WLAN LED: A red light indicates that the connection on the WLAN interface is available.
4) Local Network LEDs: A red light indicates a connection to an Ethernet-enabled computer (ports 1-4)
This LED blinks during data transmission
5) Antenna: See the next page.
6) Receptor for Power Adapter
7) Reset Button: Press this button to restore the AWR-500A to its original factory default setting
-Remove the adapter from AWR-500A-> Push the reset button and connect the adapter -> After
3~4sec, backside of WLAN and WAN LED is lighted and than finish the factory default. (It depends
on the Hardware Version. Please check it before shipment.
8) LAN Ports: These ports automatically sense the cable type when connection to Ethernet-enabled
Computers.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™6/38
1.3 Antenna Insatallation
ANT Ring Color
- Connect WAN-ANT to the Number.
- Connect Wi-Fi ANT to the Number.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™7/38
2. Package Contents
RouterModem RJ45Cable
5V DC Power Adaptor User Manual (CD-ROM)
Antenna

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™8/38
3. Using the Configuration Menu
User Login
Once properly configured, the AWR-500A will obtain and assign IP address information automatically.
Configuration settings can be done through the AWR-500A Configuration Menu. You can access this
interface by performing the steps listed below:
1. Open a web-browser. Type in the IP Address of the AWR-500A (http://192.168.2.1)
AWR-500A, ensure you enter the correct IP Address now.
<Note> If you have changed the default IP Address assigned to the AnyDATA
2. Type “admin” in the User Name field.
3. Type “admin” in the Password Field.
This is default value.
User must change password to protect from any
external hackings.
4. Click LOGIN
* If you enter wrong password, You can try to login again after 10 seconds.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™9/38
Setup Wizard > CDMA Dial-Up Setting
The Setup Wizard screen will appear.
Refer to the AWR-500A Quick Installation Guide for more information regarding the Setup Wizard.
User Name [e-mail]
Password wcall
Please retype
Your password wcall
Dial Number #777

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™10/38
Setup Wizard > Host Setting
Host Name Enter the Host Name for AWR-500A and click “NEXT”

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™11/38
Setup Wizard > Time Zone
Set Time Zone Select the Time Zone from the pull-down menu and click “FINISH”

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™12/38
Advanced Setup
Once you have logged-in, you will see the screen below.
These buttons appear on many of the configuration screens in this section.
Please click on the appropriate button at the bottom of each screen after you make a configuration
change.
Recommend you keep the default settings.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™13/38
Advanced Setup > System > System Status
INTERNET
WAN IP : Displays IP address provided by Internet Service Provider (ISP)
Subnet Mask : Displays Subnet Mask for the IP address provided by Internet Service
Provider (ISP)
DNS : Displays address of primary Domain server
Secondary DNS: Displays address of secondary Domain Server.
GATEWAY
IP Address : Display LAN IP address of AWR-500A.
Subnet Mask: Display LAN Subnet Mask of the AWR-500A
DHCP Server: Shows whether or not the DHCP server is Enabled or Disabled
Firewall : Shows whether or not the Firewall is Enabled or Disabled.
INFORMATION
PPP Status : Displays ROUTER’s connection status.
LAN MAC Address : Displays AWR-500A’s unique MAC address.
WiFi MAC Address: Displays AWR-500A’s MAC address configured in WAN port.
In WAN port.
Firmware Version: Displays firmware version of AWR-500A

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™14/38
Advanced Setup > System > Gateway Name Config
Gateway Name Enter the Gateway Name for AWR-500A and click “APPLY”

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™15/38
Advanced Setup > System > Time Zone
Set Time Zone Select the Time Zone from the pull-down menu and click “Apply”.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™16/38
Advanced Setup > System > ROUTER firmware Upgrade
→Firmware Update <Note> It is recommended that you update firmware through the LAN only.
Please turn off every application program and be careful that power supply
is not to turned off.
1) Download latest firmware from AnyDATA’s web site, and save it in hard drive.
2) Click Apply to configure IP Address and to browse firmware you have saved in your
hard drive. If you click “Apply”, you may encounter internet explorer security warning
message twice. In this case, you are required to click “Run”
3) Upon clicking RUN twice, you will have windows as below.
→From the window, enter IP address and click .
Please note that IP address, 192.168.2.1 will be displayed by default.
→Select the firmware you have saved in your hard drive by clicking , and click .
Upgrading firmware will normally take 4 to 5minutes.
Improperly upgraded software may cause fatal error to AWR-500A.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™17/38
Advanced Setup > System > Client Information
Client Information Displays client list that using this ROUTER and their information.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™18/38
Advanced Setup > System > Remote Admin
It must be set disable by default because of security reason.
Please use more complex password, if you would like to set “Enable” this feature.
Remote Admin
If it set “Enable”, It is possible to allow remote administration from internet.
Please use more complex password, if you want to set “Enable” this feature.
Remote
Administration
Port Number
Set the port number to access remote administration from internet.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™19/38
Advanced Setup > System > Password Settings
Current Password Enter the current password for your connection here
Password Enter the new Password to change for your connection here. (3-12 Characters)
Re-type password Enter your new password again for confirmation
Re-type password is case sensitive to Password.
If you lost password or want default setting, do initialization to Factory default setting.
The default ID and password are “admin” and “admin” respectively.

AWR-500A (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™20/38
Advanced Setup > System > Reset
Reset You may reboot AWR-500A by clicking Yes
If you want to change security and CDMA dial-up setting, you may use this reset feature.