AnyDATA AWR-501L User manual

AnyDATA.NET
Wireless Wi-Fi Router, AWR-501L
(User Manual)
V 1.6
2008.11.03

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™2/39
AnyDATA CDMA Module Series Reference Design Specification
Copyright © 2008 AnyDATA Corp. All Rights Reserved.
Any part of this document may not be distributed, communicated, reproduced or transmitted in any form
or by any means, electronic or mechanical or otherwise, for any purpose, without the permission of
AnyDATA Corp.
This document can be subjected to revision without further notice.
Contact Address
AnyData.Net Inc.(Korea)
DaeGo Bldg, 8
th., 1591-10
Kwanyang-dong, Dongan-gu,
Anyang City, Kyunggi-do Korea.
http://www.anydata.co.kr
e-mail: [e-mail]
Rep:[phone]
Fax:[phone]

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™3/39
Contents
1. Introduction................................................................................................................................................4
1.1 Feature.................................................................................................................................................4
1.2 Front & Back view................................................................................................................................5
2. Package Contents.....................................................................................................................................6
3. Using the Configuration Menu...................................................................................................................8
Admin Login ...........................................................................................................................................8
Setup Wizard > CDMA Dial-Up Setting..................................................................................................9
Setup Wizard > Wireless LAN Security ...............................................................................................10
Setup Wizard > Password Setting .......................................................................................................11
Advanced Setup > System > System Status .......................................................................................12
Advanced Setup > System > Gateway Name Config..........................................................................13
Advanced Setup > System > Firmware Upgrade ................................................................................14
Advanced Setup > System > Client Information..................................................................................15
Advanced Setup > System > Remote Admin.......................................................................................16
Advanced Setup > System > Password Settings ................................................................................17
Advanced Setup > System > Reset.....................................................................................................18
Advanced Setup > System > Factory default ......................................................................................19
Advanced Setup > CDMA > Dial Up Setting........................................................................................20
Advanced Setup > CDMA > Your DNS................................................................................................21
Advanced Setup > CDMA > Reconnect Settings.................................................................................22
Advanced Setup > CDMA > Preferred Mode.......................................................................................23
Advanced Setup > LAN > LAN Setting................................................................................................24
Advanced Setup > Wireless LAN > Wireless Setting ..........................................................................25
Advanced Setup > Wireless LAN > Security........................................................................................26
Advanced Setup > Firewall > Firewall Setting .....................................................................................27
Advanced Setup > Firewall > Client Filtering.......................................................................................28
Advanced Setup > Firewall > MAC Control .........................................................................................29
Advanced Setup > NAT........................................................................................................................30
Advanced Setup > NAT > Virtual Server..............................................................................................31
Advanced Setup > NAT > Port Mapping..............................................................................................32
Advanced Setup > NAT > DMZ............................................................................................................33
4. RJ11 Interface for Voice Call...................................................................................................................34
5. Troubleshooting.......................................................................................................................................36
6. Technical Specifications ..........................................................................................................................38

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™4/39
1. Introduction
1.1 Feature
- The AWR-501L CDMA 1x EV-DO IP Router supports the WLAN 802.11 b/g standard providing
constant 54Mbps data rates which are proven and secure technology.
- The AWR-501L combines the advanced CDMA EV-DO technique with the mature WAP technique
together to provide one completely feasible, secure high-performance wireless network infrastructure.
- Wireless broadband connectivity and universal compatibility with a 1x EV-DO module with tethered
data capability enables you to set up a WiFi hotspot virtually anywhere.
- Support 4 ports switching hub as LAN connection, Wireless up to 253 PC users (Recommend you ten
PC users and less)
- High-speed data connections with rate up to 3.1Mbps
- NAT & NAPT Virtual Server
- Automatic receipt of IP address with DHCP server
- 4 Indicator LED for Power, CDMA, Wi-Fi, LAN
- Browser-based configuration and easy set-up wizard
- Access Control to manage users
- User-friendly configuration and diagnostic utilities
- Industry-leading firewall security
- Supports 802.11 b/g Access Points, Routers and Gateway Server Applications

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™5/39
1.2 Front & Back view
1) Power LED: A red light indicates connection to the power supply.
2) CDMA LED: Ared light indicates that connection on the 1x or EV-DO or Hybrid port.
3) Wi-Fi LED: A red light indicates that the connection on the WLAN interface is available.
4) LAN LEDs: A red light indicates a connection to an Ethernet-enabled computer (ports 1-4) This LED
blinks during data transmission.
5) CDMAAntenna: Install a white lined antenna on the right side of the router
6) Wi-Fi Antenna: Install a blue lined antenna on the left side of the router
7) Reset Button: Press this button to restore the AWR-501L to its original factory default setting
- To restore AWR-501L to original factory setting, press and hold reset hole, and turn AWR-501L back
on. Keep it 3 to 4 seconds and then release the reset hole once until both Wi-Fi and CDMA LED light at
the same time.
8) Power On/Off Button
9) Receptor for Power Adapter
10) RJ11(“Telephon”) Port : For connection wire to phones
11) LAN Ports: These ports automatically sense the cable type when connection to Ethernet-enabled
⑨
⑨⑨
⑨⑩
⑩⑩
⑩⑪
⑪⑪
⑪
⑤
⑤⑤
⑤
 

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™6/39
Computers.
2. Package Contents
Router Modem RJ45 Cable
5V DC Power Adaptor User Manual (CD-ROM)
Antenna

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™7/39

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™8/39
3. Using the Configuration Menu
Admin Login
Once properly configured, the AWR-501L will obtain and assign IP address information automatically.
Configuration settings can be done through the AWR-501L Configuration Menu. You can access this
interface by performing the steps listed below:
1. Open a web-browser. Type in the IP Address of the AWR-501L (http://192.168.2.1)
AWR-501L, ensure you enter the correct IP Address now.
<Note> If you have changed the default IP Address assigned to the AnyDATA
2. Type “admin” in the User Name field.
3. Type “admin” in the Password Field.
This is default value.
User must change password to protect from any
external hackings.
4. Click LOGIN
* If you enter wrong password, You can try to login again after 10 seconds.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™9/39
Setup Wizard > CDMA Dial-Up Setting
The Setup Wizard screen will appear.
Refer to the AWR-501L Quick Installation Guide for more information regarding the Setup Wizard.
User Name Select the User Name for your EVDO connection here.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™10/39
Setup Wizard > Wireless LAN Security
ESSID You may change network name by entering new name
Security
From Authentication Type, you may select one of the following.
- Open System: Non-security Mode
- Shared Key (WEP)
- WPA
In order to use Shared Key (WEP)’s functionality, you need to enter password required
for Active Key. (Password must be either 5 or 13 ASCII code.)
Once you complete configuration, then you will see the message box saying “After
System Reset, Your setting value will be applied”. Click OK and reset to make the
change effective.
WPA
In order to use WPA functionality, you need to enter password required for Active Key.
(Password must be from 8 to 63 ASCII code) Once you complete configuration, then you
will see the message box saying “After System Reset, Your setting value will be applied”.
Click OK and reset to make the change effective.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™11/39
Setup Wizard > Password Setting
Current Password Enter the current password for your connection here
Password Enter the new Password to change for your connection here.
Re-type password Enter your new password again for confirmation
Re-type password is case sensitive to Password.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™12/39
Advanced Setup > System > System Status
System Status Antenna Level: Displays current Antennal level
Data rate : Display current data transfer speed
INTERNET
WAN IP : Displays IP address provided by Internet Service Provider (ISP)
Subnet Mask : Displays Subnet Mask for the IP address provided by Internet Service
Provider (ISP)
DNS : Displays address of primary Domain server
Secondary DNS: Displays address of secondary Domain Server.
GATEWAY
IP Address : Display LAN IP address of AWR-501L.
Subnet Mask: Display LAN Subnet Mask of the AWR-501L
DHCP Server: Shows whether or not the DHCP server is Enabled or Disabled
Firewall : Shows whether or not the Firewall is Enabled or Disabled.
INFORMATION
PPP Status : Displays ROUTER’s connection status.
LAN MAC Address : Displays AWR-501L’s unique MAC address.
WIFI MAC Address: Displays AWR-501L’s MAC address configured in WAN port.
In WAN port.
Firmware Version: Displays firmware version of AWR-501L
Current System mode: Displays CDMA mode

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™13/39
Advanced Setup > System > Gateway Name Config
Gatewayt Name Enter the Gateway Name for AWR-501L and click “APPLY”
<Note> Gateway name must include “,”.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™14/39
Advanced Setup > System > Firmware Upgrade
→Firmware Update
1) Download latest firmware from AnyDATA’s web site, and save it in hard drive.
2) Click Apply to configure IPAddress and to browse firmware you have saved in your
hard drive. If you click “Apply”, you may encounter internet explorer security warning
message twice. In this case, you are required to click “Run”
3) Upon clicking RUN twice, you will have windows as below.
→From the window, enter IP address and click .
Please note that IP address, 192.168.2.1 will be displayed by default.
→Select the firmware you have saved in your hard drive by clicking , and click
.
Upgrading firmware will normally take 4 to 5minutes.
Improperly upgraded software may cause fatal error to AWR-501L.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™15/39
Advanced Setup > System > Client Information
Client Information Displays client list that using this ROUTER and their information.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™16/39
Advanced Setup > System > Remote Admin
It must be set disable by default because of security reason.
Please use more complex password, if you would like to set “Enable” this feature.
Remote Admin If it set “Enable”, It is possible to allow remote administration from internet.
Please use more complex password, if you want to set “Enable” this feature.
Remote
Administration
Port Number Set the port number to access remote administration from internet.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™17/39
Advanced Setup > System > Password Settings
Current Password Enter the current password for your connection here
Password Enter the new Password to change for your connection here.
Re-type password Enter your new password again for confirmation
Re-type password is case sensitive to Password.
If you lost password or want default setting, do initialization to Factory default setting.
The default ID and password are “admin” and “admin” respectively .

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™18/39
Advanced Setup > System > Reset
Reset You may reboot AWR-501L by clicking Yes
If you want to change security and CDMA dial-up setting, you may use this reset feature.

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™19/39
Advanced Setup > System > Factory default
Factory default You may restore the AWR-501L back to factory default setting by clicking YES

AWR-501L (AWR Mobile Router)
AnyTimeAnyPlace AnyWireless Data Solutions™20/39
Advanced Setup > CDMA > Dial Up Setting
User Name Select the User Name(e.q. ufon1 or ufon2) for your EVDO connection here.
Password Enter the Password for your EVDO connection here.
Dial Number Enter the Internet Connect Dial Number.