Parts Supplied:
1x
12
1 - 2
4x
to drainage
Waste connection is dependant on the site situation; final decision
about installation of waste connection should be taken
by a suitably qualified person.
Important
• Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport.
• Please check that all parts have been supplied.
• Store the bath in a safe place until you begin installation to avoid damage.
• Assemble bath on a mat to protect against damage to bath surface.
• No claims for damages or blemishes will be accepted once the bath has been installed.
• We recommend that you do not remove your old bath until you have unpacked and inspected the new one. Please contact your local store if you have any concerns.
• Any installation should be carried out by a qualified tradesman with knowledge of statutory plumbing requirements in your area.
• This product requires a two person lift – use proper lifting techniques.
• This installation guide does not include details of waste connection; the final decision about installation of waste connections should be taken by a suitably qualified person.
Care and Maintenance
Everyday cleaning
We recommend a non-abrasive bathroom cleaner.
Warning
Never use cleaners / bleach products specifically manufactured for WC bowl cleaning as they may damage your bath. Hair dye can stain the surface of the bath.
We recommend that dye is not applied in, or over, the bath. Nail varnish can rub off on to the surface and is difficult to remove.
The bottom of the bath is close to floor level, so a hole will need
to be cut in the floor for the trap and waste pipe.
When fitting the waste, ensure the slotted
side faces the overflow channel.
Slot
Overflow
channel
3
Parts Required:
It may be possible to polish very fine scratches away without using abrasive papers: scrubbing gently with a soft brush or plastic pad (not metal scouring) and a mildy
abrasive cream cleaner. Afterwards scrub the whole area with plenty of clean water and re-polish as before.
Glosh Finish
1. Clean the surface with water,making sure no dust remains.
2. Use 800 sandpaper to polish the surface in focus with water.
3. Use 1500 sandpaper to polish the surface with water to gain a smooth surface.
4. Use 2000 sandpaper to polish the surface with water to gain a smoother surface
5. Wipe up the water with clean and dry cloth.
6. Polish with G3 wax.
7. Wipe up the remaining wax with a clean and dry cloth.
Matte Finish
1. Clean the surface with water, making sure no dust remains.
2. Use 800 sandpaper to polish the surface in focus with water to gain a
smooth surface and matte finish.
3. Wipe up the water with clean and dry cloth.
ANZZI Stone Bathtub Installation / Care Guide
For more information visit us on www.ANZZI.com or call 1-844-44-ANZZI
