AOA TECHNOLOGY AOM-1400P User manual

1
POE Fibre Switch
User Manual V1.02

2
1. Precautions
Please read the manual carefully before installing and using the switch.
Disassembling any parts of the product without authorization is strictly prohibited.
Please put the product into the standard cabinet, placed in ventilated and dry place
when using.
The product is suitable for indoor application. If it must work outdoor, please note
the grounding and light protection, so as to avoid damage by lightning strike.
Please consider the heat dissipation of the product when installing.
Around the device should be reserved enough space (more than 10cm) for proper
cooling.
Do not use the product closely to the device which has large heat productivity (such
as power supply etc.).
No water-resistant function, if used outdoor, please put the products above the
ground more than 80cm.
Please use 48V power supply, Do Not use mismatching power supply. POE power
supply must meet the power requirement of the connecting devices.
Please cut off the power first before plugging the power adaptor.

3
2. Product Introduction
AOM-P series POE switch is 10/100M unmanaged Ethernet Fibre
Switch, plug and play, easy to install.
The product provide 4/8 port POE which compliance with
IEEE802.3af/IEEE802.3at standard and POE power up to 15.4W/30W for
each port.
3. Packing List
Please kindly check the following items in the package before installation:
①1 POE Switch; ②1 Power Adaptor(DC48V);
③1 User Manual; ④1 Warranty Card; ⑤1 Conformity Certificate
If any shortage or damage found, please contact us in time.
4. Appearance Description
①AOM-1400P/AOM-1400T Front Panel
❶❷❸❹❺❻ ❼❽
②AOM-1400P-T/AOM-1400T-T Front Panel
③AOM-1800P/AOM-1800T Front Panel

4
❶❷❸ ❹❺ ❻❼❽
④AOM-1800P-T/AOM-1800T-T Front Panel
⑤POE Fibre switch patch panel description
NO.
LED
Explanation
❶
FX
On
“ON” Signal input through FX/TX
❷
LINK
“ON” Fibre link is in correct connection.
“Blink” Packet goes through Fx end.
❸
PWR
On
Power is on and normal.
❹
TP
Link/Act
100
“ON” Transfer rate of electric interface is 100Mbps
“OFF” Transfer rate of electric interface is 10Mbps
❺
L/A
“ON” Electric link is in correct connection.
“Blink” Packet goes through Tx end.
❻
TP1-8
“ON” Connected PD device, working properly.
❼
Fibre
Interface
Fibre interface: ST/SC/FC
❽
RJ45
Interface
RJ45 interface: Twisted-pair CAT5
5. Installation
①RJ45 interface: Connect the 10/100Base-TX PD device to the RJ45 jack of POE

5
switch through twisted-pair CAT5.
②Fibre interface: Connect the 10/100Base-TX PD device to the Fibre interface
of POE switch through SC/FC/ST optical Fibre. Note: Optical Fibre
connecting is in pair, when single A-B, dual TX-RX.
③Connect the power cord, plug it in, turn on the power. When turn on, the switch
will automatically initialize, and RJ45 port LED lights will be off after bright, which
means the restoration is successful.
④Check the LED lights that remains lit or not to make sure cable connected right.
Note: Default POE power supply 1/2+、3/6-(4/5+、7/8- optional).
6.Connection_Diagram