AOK AOK-120WiP User manual

The Courtyard Lamp Installation Instruction
1.The crane used to install the courtyard lamp must come with lifting platform, warning signs and flash lamp etc.
2.Electric power must be cut off before installation or maintanence of Parking Lot Light.
3.Maintenance must be performed by professional staff.
Statement
1.Electrician must have related certificates , knowledge and working experience. The work must be assigned to
each electrician based on their position and responsibility.
2.The lens of the lamp is PC + glass, which must be handled carefully during installation, otherwise will be
easily scratched and damaged. When the face of the lamp is putting on the ground, it must be protected
with soft cloth or other protective materials.
3.Installation must be proceeded when the electricity is shut off , no action taken if electricity connected.
4.Construction must be proceeded according to related regulations , including the tools and equipments used.
For example: working voltage range , Warning sign , flashing lamp , helmet , and working clothes etc.
5.Make sure the weather is suitable for high power electricity work when proceed construction.
Warning
Please read the installation manual carefully before installation and keep the manual for future use.

Step 1: Place the waterproof gasket in the groove position of the lamp arm.
Preparation for installation of the courtyard lamp
Step 2: Put the wire through the arm.
Step 3:Align the hole of bent arm with the lamp body’s screw position.
Step 4: Tighten the fixing screw with an inner hexagon wrench.
Product parts include introduction
1 2
3 4
Elastic gasket(3)
Arm(1)
Water-proof Gasket(1)
The Courtyard Lamp
Elastic gasket(3)
Set screws(3)
The torsion:13-17 N*m.
Set screws(3)
Water-proof Gasket
Groove
Arm
Vias
Arm
Wire
4# internal hexagonal wrench
The torsion:13-17 N*m
Grub screw(5)

Step 5 : Wiring, connect the L,N,GND wires on the lamp to the corresponding L,N,GND cables on the conduit.
Step 6 : Insert the elbow of the lamp into the lamp post and tighten 4 fixing screws with an inner hexagon wrench.
5
lamp-post
N
L
GND
N
L
GND
Connect the wires
*AC L(Brown or Black)
*AC N(Blue or White)
*AC (Green/Yellow or Green)
The torsion:19-22 N.m
Ø60mm
6
lamp-post
5# internal hexagonal wrench
The torsion:19-22 N.m