APG Ice Genie User manual

Step 2: Fill water into the channel at the
top of the Chamber. Fill until water
reaches just above the top row of cubes.
Note: Pour out any water that overflows
into the upper channel.
USING THE ICE GENIE™CUBE MAKER
Step 1: Insert the Cylinder into the Chamber.
(Make sure the Cylinder reaches the bottom,
creating a seal between the Cylinder and Chamber)
Note: Feel around the base of the chamber to
see if the cylinder is properly seated.
IMPORTANT SAFETY INSTRUCTIONS:
• Only use Ice Genie™ Cube Maker as described in the manual
• Always store in a clean and dry place
• Ice Genie™ Cube Maker is top rack dishwasher safe
• Keep away from extreme heat
• Ice Genie™ Cube Maker is NOT microwave safe
• Made with BPA free material
For more tips and instructional videos, visit: www.IceGenieTips.com
INSTRUCTION MANUAL
COMPONENTS
Step 1 Step 2 Step 3
Step 3: Snap the Lid onto the Ice
Genie™ Cube Maker. Place into
freezer until all the water is frozen.
(4-6 hours)
Inner Cylinder Outer Chamber Tight Seal Lid
Fill to
this point
Upper
Channel

IM1
©2018 APG. All Rights Reserved. | Patent Pending | Ice Genie is a trademark of APG.
ADDITIONAL BATCHES
CLEANINGALTERNATIVE METHOD
Step 5: Remove any loose ice that has formed on the upper
Chamber. Twist the Cylinder left/right until it is free. Then
pull upward to remove it from the Chamber. If the Cylinder
is difficult to remove, wait 30 seconds and repeat step 4/5.
Step 5
Step 4: Once frozen, remove Ice Genie™
Cube Maker from the freezer. Remove the
Lid, then firmly squeeze the Chamber on
all sides.
Step 4
Step 6: Once Cylinder is removed, squeeze
the Chamber, releasing all the ice cubes
into the middle area.
Step 6
Step 1: After all the ice cubes
are released, put the Cylinder
back into the Chamber by
pushing it into the Ice Genie™
Cube Maker. Move the cubes
out of the way by twisting the
Cylinder back and forth as you
work the cylinder all the way
down.
Note: Feel around the base
of the chamber to see if the
cylinder is properly seated.
After the Cylinder is fully
seated in the Ice Genie™
Cube Maker, simply refill
the channels of the
Chamber, leaving the
already made cubes in the
center of the Cylinder.
Once the Chamber is fully
filled, repeat steps 3-6.
Ice Genie™ Cube Maker
can store up to three
batches of ice at a
given time.
Ice Genie™ Cube Maker
can be cleaned by hand
with warm soapy water
and a sponge. Rinse
thoroughly before use. The
Ice Genie™ Cube Maker
can also be washed in the
top rack of a dishwasher.
An alternative method you
may find more convenient, is
to remove the ice cubes
from the tray and place them
into a separate bowl. Next
insert the sleeve back into
the assembly, then place the
ice cubes back into the Ice
Genie™ Cube Maker
Step 1 Step 2