Apollo Xpander XPA-IN-14102-APO User manual

XPander Remote Indicator Module
Installation Guide
General
Do not install any XPander equipment until a full site survey has been completed using the
XPander site survey tool. A maximum of 5 interfaces are permitted for each site. For sites
that require more than 5 interfaces please contact Apollo. All installation engineers must
have had certified XPander training.
The XPander Remote Indicator Module (RIM) and ancillary equipment is available under
the following part numbers:
noitpircseDrebmuNtraP
noitpircseDserapS
draCTREPXWhite
314-00692
The installation must conform to BS5839-1:2013 (or applicable local codes). The Remote
Indicator Module is suitable for indoor use only (type A).
Installation
Ensure that all Remote Indicator Modules are sited in accordance with the survey and
system design. Remote Indicator Modules must be surface mounted.
1. Remove the back plate fixing screw. Retain this for re-insertion. Insert flat bladed instru-
ment into the removal slot and remove the back plate from the transmitter/battery
section. (See Fig 1).
2. Mount the back plate in a suitable location using suitable fixings and fasteners. Ensure
the fasteners are flush with the mounting plate to avoid the risk of damaging the bat-
tery PCB. (See Fig 2).
3. Locate the Transmitter/Battery assembly onto the back plate. This has a hinged con-
nection and should be located on the top edge first.
4. Ensure that the tamper switch operates correctly. The switch should make contact with
the back plate.
5. Replace the back plate fixing screw.
6. Fit the power jumper shorting link and commission the unit according to the XPander
commissioning guide PP2286.
Set the loop address and commission the Remote Indicator according to the XPander
commissioning guide PP2286.
© Apollo Fire Detectors Limited 2017
Apollo Fire Detectors Limited, 36 Brookside Road, Havant, Hampshire, PO9 1JR, UK
Tel: [phone] Fax: [phone]
Email: techsales@apollo-fire.com Website: www.apollo-fire.co.uk
39215-219/Issue 1
4 1
XPA-IN-14102-APO XPander Remote Indicator Module

32
XPERT Card Addressing
The XPander XPERT card is specifically designed for XPander products and has profiled
address pips for ease of installation. The use of standard XPERT cards is not recommended.
Select the desired address and remove the pips indicated in black. Remove pips with a
small screwdriver.
Battery Type
atraVcinosanaP
6 x AA 1.5V Alkaline Panasonic Powerline (Size M, LR6) 6 x AA 1.5V Alkaline Varta Industrial (4006, LR6)
When replacing batteries, allow the device to power down for a period of two minutes
before installing replacements.
Note: When replacement batteries are required all batteries must be replaced together.
Technical Data
Operating voltage 2.8-5Vdc
Operating temperature –10°C to +50°C
Fig. 1 Back Plate, Fixing Screw & Removal Slot Fig. 2 Mounting Holes
XPERT Card Insertion and Removal
Removal requires access to the inside of the Remote Indicator Module. Detatch the front
cover by removing the two front assembly retaining screws allowing access to the PCB.
Insert a flat-blade screwdriver just inside the bottom edge of the RIM above the XPERT card
and disengage the card retaining clip whilst pulling the XPERT card out.