Installation Instruction
Check the parts list. Snap the two sleeves with the tapered
plastic clips (arrow & “TOP” facing up)
at the desired height on the post
Hold the shelf on its side and slide the
top of the posts through the bottom
of the shelf at each corner until there is
a snug fit. After the four posts have
been slid through the shelf corners,
position the shelf upright.
Snap the sleeves onto the posts at your
next desired shelf height. Slide the shelf
down from the top of the posts onto the
sleeves.
Screw the upper-post at each corner into
the already assembled post using the
connectors attached to the upper-posts.
Then repeat steps C and D for the
remaining shelves.
Once shelf is completely assembled, use
the foot leveler or Wheels (if applicable)
to adjust the level of each corner to
attain proper leveling.
Place liner on each shelf.
TIP: Secure the shelves in place over the
sleeves by pushing ÿrmly down on every
shelf at each corner using a rubber mallet.
(Caution: Be careful not to damage the
unit with the rubber mallet. It is
recommended to place a towel over
the shelves to help prevent damaging.)
ABCD
EFG
Note:
Tapered plastic clips need to be installed
on the same grooved line level.
It is normal to have small gaps in
between the tapered plastic clips after it
is installed on the post.
!!
