Installation Instruction
Check the parts list. Snap the sleeves into the post groove.
Sleeves must be snapped together with
the small tapered side facing up
(Note: Side of the posts with a black
plastic end cap is the top of the post).
Hold the shelf on its side and slide the top
of the posts through the bottom of the
shelf at each corner until there is a snug
t. After the four posts have been slid
through the shelf corners, position the
shelf upright.
Snap the sleeves onto the posts at your
next desired shelf height. Slide the shelf
down from the top of the posts onto the
sleeves.
TIP: Secure the shelves in place over the
sleeves by pushing rmly down on every
shelf at each corner using a rubber mallet.
(Caution: Be careful not to damage the unit
with the rubber mallet. It is recommended
to place a towel over the shelves to help
prevent damaging.)
Slide the wooden stand onto the sleeves
that you attached on step 6 and gently
push down your wooden stand until
secure.
Snap the sleeves onto the top of each
post.
Screw the castor wheels to the bottom
of each post in a clockwise direction.
A B C D
EFGH
Note:
Tapered plastic clips need to be installed
on the same grooved line level.
It is normal to have small gaps in
between the tapered plastic clips after it
is installed on the post.
!
