APURO CH919-A User manual

Model:
CH919-A
Ice Crusher
Instruction manual
CH919-A_A5_v1_20230329.indb 1CH919-A_A5_v1_20230329.indb 1 2023/3/29 17:422023/3/29 17:42

2
EN Telephone Helpline: 1300225960
Safety Instructions
The machine is intended for commercial and indoor use
by trained and skilled personnel familiar with these
instructions.
Never bypass the safety interlocks on the appliance.
Blades are sharp - handle with care !
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• DO NOT use jet/pressure washers to clean the appliance.
• DO NOT immerse the appliance in water.
• This appliance is only used for crushing ice. Do not use the
appliance for anything other than its intended use.
• Switch off and disconnect from power supply when not in use,
before assembling or disassembling, and before cleaning.
• Avoid contacting moving parts. Never place fingers or other
utensils into feeding or discharge areas.
• Ensure to check ice chute for the presence of foreign objects
before use. Use original attachments only to prevent any
damage.
• This appliance is not intended for use by persons with reduced
physical, sensory or mental capabilities, or lack of experience
and knowledge.
CH919-A_A5_v1_20230329.indb 2CH919-A_A5_v1_20230329.indb 2 2023/3/29 17:422023/3/29 17:42

3
EN
Telephone Helpline: 1300225960
• This appliance must not be used by children under any
circumstances.
• ALWAYS keep hands, hair and clothing away from the moving
parts.
• NEVER leave the appliance unattended when in use.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an
Apuro agent or a recommended qualified technician in order
to avoid a hazard.
• Apuro recommend that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your Apuro product.
Pack Contents
The following is included:
• Apuro Ice Crusher
• Instruction manual
Apuro prides itself on quality and service, ensuring that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your Apuro dealer immediately.
Installation
1. Remove the appliance from the packaging. Make sure that all protective plastic film and plastic
coatings are thoroughly removed from all surfaces.
2. Place the appliance on a flat surface, ensuring the suction feet on the bottom get a firm grip.
CH919-A_A5_v1_20230329.indb 3CH919-A_A5_v1_20230329.indb 3 2023/3/29 17:422023/3/29 17:42

4
EN Telephone Helpline: 1300225960
Before first use
1. Open the lid and wipe it clean.
2. Put a container beneath the spout, then pour warm water
through the ice jar to rinse the system thoroughly.
3. Empty the container and put it beneath the spout to
collect ice cubes.
Operation
1. Drop ice cubes into the ice chute. (Note: Suitable for
cubes up to 2x2x2 cm)
2. Close the lid in place.
3. Connect to the mains power supply and press the power
switch to start.
Warning: The blades of the crusher are self feeding!
Do not attempt to push cubes into blades with hand
or instrument.
Note: With the safety microswitch, the appliance
will stop automatically once the lid is opened during
operation.
4. After use, press the power switch again to turn Off. Then
disconnect from power supply.
Lid with
microswitch
Spout
Ice jar
Power switch
Suction feet
Ice blockage
1. Should a large cube get blocked in the crushing unit, press the power switch to turn Off. Then unplug
the unit.
2. Pour warm water through the ice jar to melt ice blockage.
3. Re-plug and re-start the appliance.
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Pour warm water through the ice jar to rinse the system thoroughly.
• Wipe the appliance housing with a damp cloth. Dry well afterwards.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault Probable Cause Solution
The unit is not working Unit is not switched on Check the unit is plugged in correctly and
switched on
Plug or lead is damaged Replace plug or lead
Mains power supply fault Check mains power supply
Overheating protection is
activated after a long period
of intensive use
Wait at least 30 minutes and try again. Placing
the appliance in a cool place will reduce the
waiting time
CH919-A_A5_v1_20230329.indb 4CH919-A_A5_v1_20230329.indb 4 2023/3/29 17:422023/3/29 17:42

5
EN
Telephone Helpline: 1300225960
Technical Specifications
Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage Power Current
Max. Ice
crushing
capacity
Ice
container
capacity
Net
Weight
Dimensions
H x W x D mm
Largest
ice cube
CH919-A 220-240V~
50-60Hz 200W 0.87A 90kg/hour 3L 5.4kg 533 x 329 x 197 2 x 2 x 2 cm
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The product must not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and environmentally safe
recycling process. For further information on how to dispose of this product correctly, contact the product
supplier, or the local authority responsible for waste disposal in your area.
Apuro parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
Apuro products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of Apuro.
Every effort is made to ensure all details are correct at the time of going to press, however, Apuro reserves the right to
change specifications without notice.
CH919-A_A5_v1_20230329.indb 5CH919-A_A5_v1_20230329.indb 5 2023/3/29 17:422023/3/29 17:42

DECLARATION OF CONFORMITY
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
• Declaración de conformidad
Equipment Type • Uitrustingstype • Type d'équipement • Gerätetyp
• Tipo di apparecchiatura • Tipo de equipo
Model • Modèle • Modell • Modello
• Modelo
Ice Crusher
CH919 -A
Application of Territory Legislation &
Council Directives(s)
Toepassing van Europese Richtlijn(en)
• Application de la/des directive(s) du
Conseil • Anwendbare EU-Richtlinie(n)
• Applicazione delle Direttive
• Aplicación de la(s) directiva(s) del
consejo
Electrical Safety
EN 60204-1:2018
EN ISO 12100:2010
Electro-Magnetic Compatibility
EN 55014-1: 2017 +A11:2020
EN 55014-2:2015
EN IEC 61000-3-2: 2019
EN 61000-3-3:2013 +A1:2019
Producer Name • Naam fabrikant • Nom du producteur • Name des Herstellers
• Nome del produttore • Nombre del fabricante
Apuro
I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s)
and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande
Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und
Norm(en) entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y
estándar(es) arriba mencionadas.
Date • Data • Date • Datum • Data •
Fecha
22nd December 2022
Signature • Handtekening • Signature
• Unterschrift Firma • Firma
Full Name • Volledige naam • Nom et
prénom • Vollständiger Name • Nome
completo • Nombre completo
Ashley Hooper
Brendan Denmeade
Position • Functie • Fonction • Position
• Qualifica • Posición
Technical & Quality Manager
Commercial Manager/ Responsible
Supplier
Producer Address • Adres fabrikant •
Adresse du producteur • Anschrift des
Herstellers • Indirizzo del produttore •
Dirección del fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
15 Badgally Road,
Campbelltown
NSW 2560
DocuSign Envelope ID: 2CBEA357-7577-45B3-B6A4-29E8A0473620
CH919-A_A5_v1_20230329.indb 6CH919-A_A5_v1_20230329.indb 6 2023/3/29 17:422023/3/29 17:42

CH919-A_A5_v1_20230329.indb 7CH919-A_A5_v1_20230329.indb 7 2023/3/29 17:422023/3/29 17:42

CH919-A_A5_v1_2023/03/29
CH919-A_A5_v1_20230329.indb 8CH919-A_A5_v1_20230329.indb 8 2023/3/29 17:422023/3/29 17:42