Aqua EZ SV523 User manual

Parts Included
Small Pool
Vacuum System
Aspiradora pequena para alberca
Item # 182117 Model # SV523

Page: 2
The Aqua EZ Small Pool Vacuum System is a manual
pool vacuum system designed specifically for cleaning
soft sided above-ground pools with low flow filtration
systems.
Assembling
• Fully extend the telescopic pole by rotating the cam and sliding the
pole out, repeat this for both sections of pole.
• Next slide pole onto the body lining up the white clips to the holes
in the pole.
• Then attach hose by applying firm pressure slide hose cuff onto the
rear of the vacuum body.
• Finally align vacuum head with front vacuum inlet, sliding it towards
the body until it is seated firmly.
Connecting To Filtration System (Part 1)
For lower intake ports ( Return Fitting ) select your
intake connector from the five provided. Take a good
look at the fitting located low on the wall of your pool.
In some cases you may have to unscrew the protective
cap attached to the return. Once you have selected the
connector that matches, screw it onto the pool return
fitting.
If you have a pool with a wall skimmer, first remove
the skimmer lid. Then while holding the skimmer weir
out of the way, remove the skimmer basket and filter.
This will help increase suction to the vacuum. Next you
need to insert the vacuum plate that should have come
with your pool into the skimmer.

Page: 3
Connecting To Filtration System (Part 2)
Once the intake port or vacuum plate has been
installed you need to connect your hose to it. Fully
submerge hose and vacuum making sure that all
air has been removed, any air bubbles will hinder
vacuums ability to remove debris. While keeping
the hose fully submerged, connect it to the intake
connector or return fitting on your pool.
Vacuuming
When vacuuming your pool start in the center and work your way
out. Guide the vacuum at a 45 Degree angle. Downward pressure
is not needed, let the vacuum work for you. If you are experiencing
reduced suction, check your hose, vacuum and filtration system for
air bubbles. A full collection bag will also cause decreased suction.
Empty when necessary. Remove cartridge filter element if more
suction is needed.
Cleaning Vacuum
Cleaning your collection bag should be done once
vacuuming is completed or if the bag gets full of
debris. Remove vacuum from water. Open top latch
to expose vacuum chamber. Slide bag out of vacuum
body and dump out debris. Then reinstall bag and
close vacuum body.
Thank You
Thank you for choosing Aqua EZ for all your pool maintenance needs.
For Helpful Hints and Notes see back page.

Page: 4
Helpful Tips
• Vacuum works with suction from pump. Remove or clean cartridge if
necessary. Large debris will be trapped in collection bag inside vacuum.
• Insure all air is removed from vacuum and hose. Even a small amount of
air will affect the performance of cleaner.
• Use gentle pressure when vacuuming.
DO NOT STAB OR THRUST VACUUM HEAD AGAINST VINYL LINER.
• Empty hose and vacuum of water when not in use.
• Visit aquaez.com or call directly 1-877-852-4264 if you have additional
questions.
• Additional parts are available at [email protected] or call directly
1-877-852-4264 Mon – Thurs 8AM-5PM or Friday 8AM-3PM
Notes