Aqua Lung Reflector Kit User manual

0 7
53242 18088
PN 427047

Installation Instructions
Re ector Ring
1.
Unscrew valve cap (1).
2.
Place re ector ring (2) over threads (3).
3.
Properly position spring inside valve: Wide end of
spring  ts in recessed hole on inside of cap; small
end of spring  ts over small boss on valve plate (4)
.
While pulling on cord to keep spring in place,
thread valve cap onto BC.
4.
Fully in ate BC. Test dump valve by pulling on
string. Re-in ate BC. Let stand for 30 minutes.
BC should remain in ated.
Re ector Patch
Note: Re ector patch is normally place above in ator
hold-down. On some smaller BCs, it must be attached
below hold-down
.
1.
Before installing re ector, attach low-pressure
in ator hose (1).
2.
Disconnect in ator hold-down and lift up cor-
rugated hose (2).
3.
Re ector patch is secured with “sandwich-style”
hook & loop attachment. Place re ector against
hose. Wrap inside hook  ap (3) around in ator
hose. Secure loop  ap (4) to hook  ap. Secure
outer hook  ap (5) to loop  ap.




















Literature PN 18319, Rev 7/2004