Aquasanita EKO 2561 User manual

AQUASANITA
EKO 2561
NOTE
RECOMMENDATION
01
02
03
Installation instructions
Minimum water pressure: (0.5 bar)
Maximum water pressure: (10 bar)
Maximum hot-water temperature: 80°C
Recommended hot water temperature: 70°C
TECHNICAL DATA
All AQUASANITA taps have a sturdy construction and are functional, reliable and simple
to install. They are easy to turn on and o and the selection of water temperature and
ow is easy to control. 360 rotating spout allows installing the tap handle on the right
or on the left.
Congratulations on buying our product. Kitchen tap Eko is functional and convenient to
use. Quality and durable body is powder coated. This tap is perfect for articial granite
AQUASANITA sinks.
Prior to connecting the tap to water supply, rinse the pipes of the water
supply system well in order to clean out the accumulated sediments (it is
especially important when connecting to a new water supply system).
After connecting the tap to water supply, gradually open the water supply
valve and check, whether all connections of the tap are sealed and not
leaking. Then test the tap and all its functions.
We recommend entrusting the installation of the tap to professionals. In
order to prevent particles from the water supply system getting into the tap,
install a water lter (100 microns) prior to installing the tap.

04
05
06
www.aquasanita.com
1
2
3
4
5
6
7
8
9
10
11
12
1
1
1
1
1
1
1
1
1
1
1
1
PART LIST AS FOLLOWS:
1. Close o hot and cold water supply.
2. Remove (unscrew) the aerator (to avoid clogging the aerator at the rst
start-up of water).
3. Fasten the mixing valve on the sanitary ware, using the supplied
fasteners. Connect the exible hoses to the valve. The exible hoses should
be screwed into the valve slot only by hand without using tools or applying
excessive force, because this can cause damage the hoses or the valve.
4. Connect the valve to the water supply system, using the connecting
ttings (upset couplings). Turn on the water supply. In the closed position of
the valve, check sealing of all the connections. If necessary, make extra
tightening and sealing of the connections ( be sure to close the shut-o
valves on water supply pipping).
5. Start the cold and hot water running for a short period of time (to wash o
the pipes), then close the water supply and install (tighten) the aerator.
INSTALLATION
GUARANTEE 5 YEARS
Manufacturer is liable for manufacturing and material defects of an item
during a guarantee period. In case of detecting such defects, return your
tap to the seller. Keep purchasing documents during the whole guarantee
period and attach it to the tap returned.
The manufacturer shouldn‘t take responsibility when:
- the users fail to follow the intallation instruction;
- the users use the product not for its functional purpose;
- the users use spare parts of another manufacturer;
- if the faucet was installed by unqualied person;
- if the faucet was wrongly used;
- if the defect appeared because of wrongly installed faucet;
- if the surface of the faucet and its spare parts were mechanically defected
or scratched;
- if any of mechanical impurities has aected the inner of the faucet;
- if the faucet was delivered back to the seller not of the full conguration or
without orginal packaging.
Shower heads, shower hose and spout are not included in the after sale
guarantee.
handle
cap
bonnet nut
cartridge
connecting case
spout
aerator
aerator case
cartridge holder
button
xing part
inlet hose
No. Name Quantity