44
12
85155 Pg. 2
LIMITED WARRANTY
This aquarium stand is under warranty by Marco Group, Inc. against defects in material and workmanship for 90 days from the date of purchase. If any
component of the stand is found to be defective, you may contact us for replacement provided it has not been modified, damaged or misused.
(Proof of date of purchase must be provided).
THIS WARRANTY IS VOID if the aquarium stand is modified, if it is not placed on a flat, level surface, if it is used with a tank other than it is designed, if it is
moved with the tank in place or if it is used for other than it’s intended purpose.
This warranty is limited to replacement of the stand only. Warranty does not cover loss of fish, personal injury, property loss or damage arising out of use of the
aquarium stand. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you. This warranty gives you specific legal rights and you may have other rights that vary from state to state.
5400 DONIPHAN DRIVE
NEOSHO, MO 64850
FFOOLLLLOOWWSSTTEEPPSSIINNOORRDDEERR::
1. PLACE ONE SPACER “E” INTO THE HINGE
HOLE IN BOTTOM OF PART #1. NOW PLACE
THE BOTTOM DOOR HINGE INTO THIS SPACER.
2. PLACE ONE SPACER “E” ONTO THE TOP
DOOR HINGE AND INSERT IN THE HINGE HOLE
ON TOP PART #2. SECURE TOP HINGE “G” TO
DOOR WITH (2) SCREWS “F” AS SHOWN.
IMPORTANT
IF DOOR DOES NOT OPEN PROPERLY OR IF PART
“G” MOVES WHILE OPENING DOOR, CAREFULLY
RE-CHECK THE INSTALLATION OF PART “G”.
A COMMON MISTAKE IS TO INSTALL PART “G”
BACKWARDS. PLEASE REFER TO PICTURES
IN STEPS 3 & 4 FOR CORRECT ORIENTATION.
STEP 1
IMPORTANT!!!
NOTE ORIENTATION OF
PART “A”. OPEN (HOLE)
SECTION MUST FACE
TOWARDS THE
CORRESPONDING HOLE
IN EDGE OF PARTS #4 & #5.
(ALL 20 PLACES)
THE ARROW ON TOP OF
PART “A” WILL ALSO
POINT TOWARDS THE
CORRESPONDING HOLE
IN EDGE OF PARTS #4 & #5.
TOP VIEW
OF “A”
FRONT VIEW
OF “A”
Insert (20) Part “A”
into holes as shown.
4
B
A
2
1
3
NOTE! HOLES & PART “B”
SHOWN HERE ARE ON
UNDERSIDE OF PART #2
STEP 2
Connect Parts #4 & #5 to
BOTTOM PART #1 FIRST.
Using a screwdriver, turn Part
“A” clockwise to lock onto Part
“B” on BOTTOM Part #1.
Repeat with TOP PART #2.
5
5
This side
faces to
INSIDE of
stand This side
faces to
INSIDE of
stand
STEP 3
F
Inside of
Door
Attach hardware to
BOTTOM of door FIRST.
E
Outside
of Door
STEP 4
E
F
G
BOTTOM
DOOR
HINGE
STEP 5
D
2X
Screw (20)
Part “B”
into holes
as shown.
2X
NOTE:
Lock bottom
assembly FIRST.
NOT
USED
NOT
USED
HINGE
HOLE
55
4
4
4
This
side
faces to
INSIDE
of stand
IMPORTANT
NOTE!
YOU
MUST
POSITION TANK
TOWARDS THE
BACK SIDE
OF STAND.
H
DC
G
