Aquilosports Cryo-Compression Recovery Pants System Instruction manual

1
2
3
4
Fill the tank to 1 or 2 users’
line (for both water and ice)
Fit Recovery Pants around the
body using included Velcro
flaps
There are 3 flaps on each leg
and 2 flaps for hip
adjustments
Connect tubing from Aquilo
control unit to Recovery Pants
Quick User Guide
Plug Aquilo Control Unit into power
source using provided cable (do not
substitute power cable). Then press
Power (metal button). The Power
Button will turn blue

Power on
Activate water pump by holding the ON
button for 3 seconds
Start water pump by pressing the ON
button again
A blue light (pump) starts blinking blue and
indicates that the water pump is operating
If the control unit is charged, no power
source is required
If the battery level is too low, the machine
will not power on without the power cable
Set Time to your preference using +/-
buttons. We recommend 20 minutes
Follow instructions to power on the
water pump (on screen)
1
1
2
2

Optional Pulse feature will allow water pump to run
for 2 minutes, off for 30 seconds, repeat
Charging the Aquilo Control Unit
Plug Aquilo Control Unit into power source using provided
cable (do not substitute power cable). Then press Power
(metal button). The Power Button will turn blue
The Battery level lights (green) will be flashing with their
battery level until full
1
1

Recommendations
After the duration of your session, wait 2-3 minutes
before unplugging the connectors from the
Recovery Pants. This will allow the water to drain
from the pants back into the tank
Drain tank after each session using provided drain
hole/caps on either side of the tank. Some water
remaining in tank is okay.
Remove plastic screen protector, if desired. This is
easiest to do by peeling the plastic off by the Power
Button (metal)

www.aquilosports.com