ARBICO Organics Gypsy User manual

Gypsy Moth Trap Assembly Instructions
Pop out the paper inserts from
the eight entry ports of the trap
body and crease the body lines
several times.
Bottom of Trap
Open and invert the trap, then
t the bottom together and
staple, as shown below, with
stapling pliers.
Trap Hood
On the trap hood, pop out the
4 ller squares. Crease center
tabs upwards. Crease solid
corner lines.
Port
Entries
Slits Above
Port Entries
Staples
1 of 2
Solid
Creases
Tabs
Slide the hood (shiny side up) over the top of the
trap and down the body of the trap until the tabs
in the center of the hood are below the slits
located above the eight entry ports.
Now slide the hood back up the body of the
trap, so that the small tabs on the hood slide into
the slits on the trap body. Staple the tabs to the
inside of the trap body.
Staple the gypsy moth lure to a twist tie or twine.
The lure should hang down the center of the trap.
Attach the twist tie or twine to the center hole in
the top. Secure with staple.
Increase moth capture by adding an insect
trap adhesive such as Stiky Stuff Adhesive or
Tangle-Trap Sticky Coating to the inside of
the trap.
Tabs Stapled
to Trap Body
Lure
Your Gypsy Moth Trap Includes:
Trap Body & Trap Hood (Gypsy Moth
lures sold separately)
Assembly Requirements:
Stapler, Twine & Twist Tie, 1 Binder Clip

Staples
Binder Clip
Fold the top ends of the trap together.
(The end with the diagonal crease is the
pour spout — do not staple the pour
spout.) To close the trap, staple the sides
of the top half of the top of the trap that
is not the pour spout together. Use a
binder clip to secure the sides of the pour
spout together.
Assembled Gypsy Moth Trap
To hang the trap, staple a 24 inch length of
cotton twine (20 ply or stronger), to the top
center of the gypsy moth trap.
Hang traps in trees 4-5 feet off the ground
when adult gypsy moths are active.
2 of 2
© 2022 ARBICO Organics®All rights reserved.
Gypsy Moth Trap Assembly Instructions (continued)
Optional:
• Stiky Stuff Adhesive Or
• Tangle-Trap Sticky Coating